7
1 First assemble the legs of the frame by fastening the angle sections with the bolts and then fit
the side panels, if applicable (fig. 3).
◗ NB: the holes in the side panels must be on the front side.
2 Place the couch on the legs carefully. Make sure the legs slide steadily into the appropriate
openings in the couch (fig. 4).
◗ NB: the openings for assembling the canopy must be located at the back of the couch.
3 If necessary, you can move the couch slightly by sliding its legs across the floor or by carefully
lifting it slightly off the floor together with another person. Make sure there is enough free
space beside (at least 50 cm) and behind (at least 30 cm) the appliance.
◗ Never try to move the appliance in the manner shown in the picture.This could cause the
frame to become detached from the couch (fig. 5).
4 Lift the canopy together with another person and position its connecting tubes over the
connecting holes. Slide the tubes steadily into the connecting holes of the couch (fig. 6).
B
Be careful not to get your fingers stuck between the couch and the canopy.
B
Make sure the cord does not get stuck between the couch and the canopy.
5 Remove the protective foil from the acrylic sheets of the canopy and couch (fig. 7).
6 Plug the connecting cable into the socket in the couch (fig. 8).
◗ If you want to remove the connecting cable, follow the instructions shown in the picture
(fig. 9).
7 Place the front panel and fasten it with the screws (fig. 10).
The only purpose of the panel is to enhance the appearance of the appliance.
8 Insert the mains plug into the wall socket.
Using the appliance
1 Switch the appliance on by setting the required tanning time on the timer (fig. 11).
B
For the correct tanning times, see 'Tanning sessions: how often and how long?'
2 Push the canopy backwards so that you can lie down on the couch.When you are lying on
the couch, pull the canopy back into horizontal position (fig. 12).
B
NB: when the appliance has not been used for some time, the hinges of the canopy may squeak
when you open or close the canopy for the first time.
3 Switch the body cooler on by means of the switch (fig. 13).
◗ Select the desired airflow: n or b (fig. 13).
4 HB589 only: if you like, you can also switch on the facial tanner (fig. 14).
◗ Select , for 75% of the full intensity or m for full intensity (fig. 14).
5 Don't forget to put on the protective goggles provided.
6 During the last minute of the session you will hear a beeping sound.
Cleaning
Always unplug the appliance and let it cool down before you start cleaning it.
Do not use abrasives or scourers.
Never use liquids such as alcohol, methylated spirits, petrol or acetone to clean the acrylic sheet
as this may cause irreparable damage.
ENGLISH
