SET-UP FOR USE
Advice
Carefully read the complete procedure before starting!
Your equipment is a Philips brand:
1 Press the mode selector key for the device you want to
operate.
2 Press the power key to test.
– The green indicator LED under each device (TV, VCR, SAT
or DVD) lights up to confirm the mode you’re in.
Check
Press a few keys to check correct response.
Your satellite receiver is a Sky Digital box:
1 Press the mode selector key to select SAT and make sure
the satellite box is switched on.
2 Press and hold keys 1 and 3 simultaneously -for about 3
seconds- until the green LED lights up. Then release the
keys.
– The green LED should stay on.
3 On the keypad, press keys 0, 8, 7 and 4, within 30
seconds.
– The green LED flashes twice to indicate successful set up.
Your equipment is of another brand, or your
equipment is a Philips brand, but not all keys
respond correctly:
1 Press the mode selector key to select the device (TV, VCR,
SAT or DVD) you want to operate.
2 Look up the brand name of the device you want to
operate in the code list (centre of this manual).
Make sure you choose the correct code list for your device!
3 Make sure the device is switched on.
4 Press and hold keys 1 and 3 simultaneously - for about
three seconds- until the green LED lights up. (Release the
keys: the green LED should stay on)
5 Enter your 4-digit code using the number keys, within
30 seconds.
– The green LED flashes twice.
Check
That’s it! Press a few keys to check correct response. If
response is not correct, repeat procedure beginning at step 1.
Note
- If the LED displays one long flash, the code was not
recognised. Please go back to step 1 and repeat the
procedure, using the next 4-digit code in the list.
- If no key is pressed within 30 seconds, you have to start
again at step 1.
Advice
Carefully read the complete procedure before starting!
Instructions for use
English
4
