A DVICE
Carefully read the complete procedure before starting!
You do not know the brand of your TV/you can
not find the right code in the code list » auto
search:
1 Make sure the TV is switched on.
2 Press and hold keys 1 and 3 simultaneously -for about
three seconds- until the green LED lights up.
(Release the keys: the green LED should stay on)
3 Press the power key to start the search. Make sure that
you keep the remote control pointed at your TV.
– Each time the green LED flashes, another code is sent.
When the right code is found, the TV switches off.
Immediately press the power key to stop the search.
If the green LED flashed again after the TV switched off,
this means you missed the correct code! If you missed the
code, follow the next procedure, starting at step 4. If the
LED did not flash again after the TV switched off, go to
step 6.
4 Switch the TV manually back on.
5 Press ‘PROG-’ (down only!) repeatedly to send previous
codes until the TV switches off again.
6 Press the power key to lock the correct code in the SBC
RU510’s memory.
– The green LED flashes twice.
C
HECK
Switch TV on manually. Press a few keys to check correct
response. If response is not correct, repeat procedure beginning
at step 1.
N
OTE
- The search time averages about 90 seconds.
(Maximum search time is 5 minutes for TV).
- Autosearch stops automatically after all codes have been
tested.
MAKE A NOTE OF YOUR CODE!
A
DVICE
Carefully read the complete procedure before starting!
Note the code inside the battery case and in the codelist in
the centre of this booklet. This may be useful if you ever need
to set up the SBC RU510 again. You used the auto search
procedure or you forgot to note the code after set up? No
problem! You can still ‘read out’ the code from the remote:
1 Press and release keys 1 and 6 simultaneously.
Important: after pressing the keys, you have to release them
immediately!
– The green LED lights up.
2 Press the two digits key.
– The green LED goes out.
Instructions for use
4
English
