5
A
A
A
A
A
A
A
F
G
8
9
10
11
12
13
14
15
16
17
B
C
D
E
Ignition keys and
locks
Two keys are supplied with the scooter
and are identified by a number. Please
keep them apart and note the reference
number. The ignition key :
- Makes the contact when starting
- Locks the steering
- Unlocks the saddle
- Starter switch
- Engine stopped
- Electrical contact position. Starter
and signal functions may be used.
- Opening the seat
- Steering locked
- Light switch
To comply with new European
legislation the lighting of your vehicle
is now permanent.
- Starter button
Start as described on page 7
-High beam/low beam
indication lights
- Turn signal light
switch
To signal a change of direction :
- To the right, push the switch to
- To the left, push the switch to
The indicator is turned off by pressing
the central button
- Horn button
* According to the model
Electronic display
- Mileage counter
- (TOTAL) Indicates the total distance
travelled either in Km or in miles.
- By pressing button the display
will change to the trip counter and vice
versa.
- Trip counter
- (TRIP) Indicates the trip distance
travelled in Km or in miles.
- The trip counter can be reset by
keeping button pressed down
for more than 5 seconds when the trip
counter value is displayed.
- Digital clock
The clock displays the hours and the
minutes, the ‘‘:’’ flash on and off. In
order to set the time (which must be
done with the vehicle at a standstill
and with the counter on ‘TOTAL’),
keep button pressed down for
more than 5 seconds, the hour figure
will flash on and off; to change it,
press button . In order to move
to the next figure, keep button
pressed down for more than 5
seconds. When the last figure has
been set, keep button pressed
down for more than 5 seconds.
- Fuel level indicator
The 8 segments indicate the level of
fuel; the vehicle is running on its
reserve capacity when the last two
segments start to flash. Its autonomy
is thus approximately 20 km.
- Service indicator *
After the first 500 km and every 5000
km thereafter, the indication ‘‘- - - -’’
appears on the clock display for 10
seconds each time the engine is
started; this means that the vehicle
should go in for a service. In order to
reset the counter after the service,
turn on the ignition whilst simultane-
ously pressing button
* According to the model
Oil warning light*
Normal operation
- The warning light goes on when the
ignition is turned on, and shall remain
lit as long as the engine is not running.
- The warning light shall go off when
the engine is running.
Abnormal operation
When the ignition is turned on,
engine stopped
The warning light does not go on
- Do not start the engine to avoid
damaging it and go to a local
dealer.
When the engine is running
The warning light stays on
Turn off the ignition and check the oil
level.
- You must add oil before riding
out.
If the warning light stays on although
there is enough oil.
- Turn off the ignition in order
not to damage the engine and go
to a local dealer, with the engine
stopped.
When riding
The warning light flashes quickly
(approximately 6 times per
second) :
This means that the oil pump is out of
order.
- Stop immediately according to
traffic conditions and road traffic
regulations. Turn off the engine in
order not to damage it, and go to a
local dealer, with the engine
stopped.
* According to the model
