Electrical safety
Before use, always check that the mains •
voltage is the same as the voltage on the
rating plate of the appliance.
The appliance is not intended to be •
operated by means of an external timer or
separate remote-control system.
Connect the appliance to an earthed wall •
socket. If necessary, use an earthed extension
cable of a suitable diameter (at least
3 x 1 mm
2
).
For additional protection, install a residual •
current device (RCD) with a rated residual
operating current that does not exceed
30 mA.
Make sure that water cannot enter the •
contact plugs of the mains cable and the
extension cable.
Always fully unwind the mains cable and •
the extension cable.
Make sure that the mains cable does not •
hang over the edge of a worktop and cannot
be caught accidentally or tripped over.
Keep the mains cable away from heat, oil •
and sharp edges.
Do not use the appliance if the mains cable •
or the mains plug is damaged or defective.
If the mains cable or the mains plug is
damaged or defective, it must be replaced
by the manufacturer or an authorised
repair agent.
Do not pull the mains cable to disconnect •
the mains plug from the mains.
Disconnect the mains plug from the mains •
when the appliance is not in use, before
assembly or disassembly and before cleaning
and maintenance.
Safety instructions for slow juicers
Do not use the appliance outdoors.•
Do not use the appliance in damp •
environments.
Place the appliance on a stable and flat •
surface.
Place the appliance on a heat-resistant and •
splash-proof surface.
Do not place the appliance on a hob.•
Make sure that the appliance does not come •
into contact with flammable material.
Keep the appliance away from heat sources. •
Do not place the appliance on hot surfaces
or near open flames.
Make sure that your hands are dry before •
touching the appliance.
Beware of sharp parts. Do not touch •
moving parts.
Store the appliance in a dry place when •
not in use. Make sure that children do not
have access to stored appliances.
U.K. Wiring instructions
The wires in the mains lead are coloured in
accordance with the following code:
BLUE NEUTRAL
BROWN LIVE
GREEN/YELLOW EARTH
As the colours of the wire in the mains lead of
this appliance may not correspond with the
colour markings identifying the terminals on
your plug, proceed as follows:
The wire which is coloured BLUE must be
connected to the terminal which is marked
with the letter N or coloured black.
The wire which is coloured BROWN must be
connected to the terminal which is marked
with the letter L or coloured red.
The wire which is coloured GREEN/YELLOW
must be connected to the terminal which is
marked with the letter E or
and is coloured
GREEN or GREEN/YELLOW.
If a 13Amp (BS1363) plug is used, a 13Amp
(BS1362) fuse must be fitted, or if any other
type of plug is used, a 13Amp fuse must be
fitted, either in the plug or adaptor, or on the
distribution board.
Warning! This appliance must be earthed.
Disclaimer
Subject to change; specifications can be
changed without further notice.
