130211
10
Verklein
Vergroot
Pagina terug
1/20
Pagina verder
ACCESSORIES
15
ORDERING FILTERS
As with any kitchen appliance,
correct maintenance is
important for the durability of the
cooker hood. If your
extractor hood is fitted with a
fibre filter, this can be replaced
by a was-hable aluminium filter.
This aluminium filter will be sent to
you when ordered in writing or by
telephone.
Ordering accessories
type WA/OWA 10 200 49 50 52 68
MWA 100 48 490 92 900
51 59 600
carbon filter KF 20 KF49 KF20 KF68
aluminium filter AV20 AV 20 * AV20 * *
chimney - - TP49 - TP49 TP68
* supplied
GB
14
USING YOUR HOB
USING THE OWA 600/900 AND
WA 68
Control switches
Fig. 4
A = general switch
B = light switch
C = speed decrease switch
D = speed increase switch
E = display
Installation
When the hood is first switched
on it runs through a phase of
reset and self-cheking. At the end
of this phase a stand-by phase
will be reached: motor and
lamps will be switched off and
the display will show its lower seg-
ment.
Switching on the hood
Switch on the hood by pressing
switch A. The motor will not run
and the display will show 0. You
will set the motor in motion by
pressing switch D, the display will
show 1.
Change speed by using switches
C and D: by pressing either of
them the speed is immediatly
changed by one step.
Continuous pressure on C and D
at the same time for more than 2
seconds causes the motor to
work at its highest speed for 4
minutes. The display shows 9.
After that the hood will return to
the stand-by mode.
Switching off
Pressing switch A turns the motor
off and the hood will return to its
stand-by mode. When the hood
is switched on again the motor
resumes operation at the speed
previously selected.
Using the hood in recirculation
mode
After resetting, the motor speed is
set for use in the exhaust mode.
In order to select the recirculation
mode one of the following steps
must be taken: pressing switch D
in the stand-by mode shows “A”
on the display. This stands for
selection of the exhaust mode.
Pressing switch C and D at the
same time, while on stand-by,
changes operation to recircula-
tion mode. The display shows “F”.
Any further pressing of C and D
switches will select the exhaust
mode of operation.
Cleaning/replacing filters
After cleaning the grease filter
the bookmark “G” on the display
will disappear by pressing switch
C for more then 10 seconds. After
replacing the carbon filter the
bookmark “C” on the display will
disappear by pressing switch D
for more then 10 seconds.
GB
10

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Pelgrim-wa-70

Zoeken resetten

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Pelgrim wa 70 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Pelgrim wa 70 in de taal/talen: Nederlands, Duits, Engels, Frans als bijlage per email.

De handleiding is 0,12 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info