Use
See fig. 1 and 2.
After installation
When the hood is switched on for the first
time, it runs through a phase of reset and self-
checking. At the end of this phase a stand-by
phase will be reached: motor and lamps will
be switched off and teh display will show its
lower segment.
Switching on
The hood is switched on by pressing switch
(1). The motor will not run and the display will
show 0. The motor is set in motion by pressing
button (4) , the display will show 1.
Change the speed by pressing switch (3) or
(4). The speed is decreased or increased by
one step. Continuous pressure on switches (3)
and (4) at the same time for more than 2
seconds causes the motor to work at its
highest speed for 4 minutes. The display
shows a
9 blinking. After that the hood will
return to the stand-by mode.
Switching off
Pressing switch (1) turns the motor off and the
hood will return to its stand-by mode. When
the hood is switched on again, the motor
resumes operation at the previously selected
speed.
Using the hood in recirculation mode
After the reset phase, the motor speed is set
for use in exhaust mode. In order to select the
recirculation mode, the following steps must
be taken: pressing switch (4) in the stand-by
mode shows A on the display. This stands for
selection of the exhaust mode. Pressing
switch (3) and (4) at the same time, while on
stand-by, changes operation to recirculation
mode. The display shows F. Any further
pressing of switch (3) and (4) at the same time
will select the exhaust mode of operation.
Replacing carbon filters
The carbon filter must be used if the cooker
hood is not connected to a duct (see
extraction systems on page 8).
Note:
■ The carbon filter must be replaced at least
twice a year, depending on how much the
cooker hood is used.
■ Carbon filters cannot be cleaned to use
again.
■ Saturated carbon is harmful to the
environment, replace the filter regularly.
Every time the character G appears on the
display, the filter panel must be cleaned.
Saturation of the carbon filter is shown on the
display by the character C.
Removing the filter panel
Switch off the electricity! Remove the plug
from the socket or switch the electricity off at
the mains. Pull the filter panel down (see
fig. 4).
9
USE/FILTERS
