MOUNTING
33
■ Fit the attachment material to the door, as
indicated in figure 9b. Be careful of the
position of the flat sides for the upper
attachment pins: these must point
outwards.
■ Attach the panel to the door of the
dishwasher by placing the lower hooks
over the pins on the left and right of the
front. Press the upper pins into the slots of
the plastic section.
Disassembling door panel of 45 cm
dishwasher
■ Pull the pins in the left and right side of the
panel outwards with the aid of the plastic
tool provided (C).
Adjusting the spring tension (see fig. 10)
fig. 10
■ As standard setting, the door is adjusted to
the lowest spring tension.
■ Increase the tension of the spring by
turning the two adjusting screws (A) in a
clockwise direction with a screwdriver.
The tension of the spring is correct if the
door is in a state of equilibrium when open.
Positioning (see fig. 11)
fig. 11
Note
You should not allow the hoses to develop
kinks or get flattened during the installation of
the dishwasher in the recess.
■ Mount the metal plate provided to the
underside of the unit top, moisture could
damage the unit top.
■ Adjust the dishwasher so that it is level.
■ Mount the dishwasher to the unit top.
■ Mount the plinth in place.
■ Carefully open the dishwasher to check
whether or not the door hits the plinth.
■ If this is the case, mark the part of the
skirting-board to be removed.
Leave a free space of three millimetres
between the door and the skirting-board so
that the door can open and close freely.
■ Make the sawn-off piece of skirting-board
waterproof - with paint, for example - and
replace the skirting-board.
A
