Installation
General
When the appliance does not have a
connecting cable and plug, then it may be
connected to the mains only by an approved
installer.
After installation the wall socket and plug
must be accessible at all times.
Please note:
The power rating and required mains voltage
are shown on the rating plate at the back of
the oven. Connection should take place
according to national and local regulations.
A hob should preferably not be positioned
immediately above a refrigerator or freezer
built-in below the worktop. If the hob has to be
fitted above a refrigerator or freezer, ensure
that the hob is well insulated.
Wiring diagrams (Fig. 6)
■ There is a label showing the wiring
diagrams on the underside of the appliance.
■ The hob without any switches on the hob
itself, is fitted with a 12 pin plug which
should be connected to the oven or a
control panel.
■ The seal between the hob and the work
surface must be moisture-proof. The work
surface must be absolutely level, as must
the hob of course!
If the work surface is tiled it could be
necessary to use liquid silicone rubber
instead of the sealing strip.
■ If the hob is enclosed between the back
and side panels a minimum distance of
400 mm from these panels should be
observed (Fig. 7).
■ Tighten the mounting clips equally (Fig. 8).
INSTALLATION
15
