31
CLEANING/INSTALLATION
Fig. 7c
■ Remove the filter group by pulling the
handle (A).
■ Press on the two clips (B) and remove the
filter (C) straight out.
■ Press on the two clips (E) and remove the
filter mesh (D) straight out..
■ Clean filter mesh and filter with a brush
under running water.
■ Reassemble the filter mesh and filter in
reverse order.
Installation
Electrical connection
230 V – 50 Hz
General
When the appliance does not have a
connecting cable and plug, then it may be
connected to the mains only by an approved
installer.
Note:
The power rating and required mains voltage
are shown on the rating plate. Connection
should take place according to national and
local regulations.
If the input of the appliance exceeds 3 kW, the
appliance has to be connected to an outlet
with a rated current exceeding 13 Amp.
Technical information
Connected load kW see identification
plate
Dimensions:
Max. height mm 870
Min. height mm 820
Width mm 596
Depth mm 550
Door panel:
Max. height* mm 600
Min. height mm 500
Depth mm 598
Control panel
Max. height mm 155
Min. height mm 115
Plinth:
Max. height mm 170
Min. height mm 100
* at minimal control panel height
What else you should watch out for
■ Always fit tap, drainage and earthed
plug/wall socket within reach.
■ Make sure that the skirting-board can be
removed. It must be possible to take the
dishwasher out of its recess for
maintenance or repair work.
D
E
