684713
58
Verklein
Vergroot
Pagina terug
1/310
Pagina verder
58
GB IE
Sawing in sections:
Saw off large or long branches in sec-
tions so that you have control over the
place where the branch section lands.
Saw the lower branches of the tree off
rst in order to make it easier for the
branches that have been cut off to fall
to the ground.
After the cut is completed, the weight
of the saw increases abruptly for the
operator, as the saw is no longer
supported on the branch. There is a
danger that you will lose control of the
device.
You should only pull the saw out of the
cut with the saw chain running in order
to avoid jamming.
Do not saw with the tip of the cutting
equipment.
Do not saw the bulge at the base of
the branch because this will prevent
the tree from healing.
Working Safely
Do not use the high pruning saw when
standing on a ladder or in an unsafe
position.
Do not be tempted to make unconsid-
ered cuts. Doing so may endanger
both yourself and others.
Children must be supervised to ensure
that they do not play with the equip-
ment.
Long use of the equipment can result in
vibration-related circulatory disorders
in the hands. However, the length of
use can be extended by using suitable
gloves or taking regular breaks. Note
that a personal tendency for poor cir-
culation, low outdoor temperatures, or
high gripping forces during work will
reduce the length of use.
While using the pole pruner/hedge
trimmer, pay attention to the specied
working angle of max. 60°
in or-
der to ensure that you work safely with
the device.
Always stand on the slope above or to
the side of the branch to be sawn.
Hold the device as close as possible
to your body. This will ensure the best
balance.
Maintenance/Cleaning
Repair and servicing work not
described in this manual should
always be carried by our Service
Centre. Use only original parts.
Remove the rechargeable battery
from the device before cleaning
and maintenance.
Wear gloves when working with
the blade, saw chain and cutter
bar.
Carry out the following maintenance and
cleaning work regularly. This will guaran-
tee a long and reliable service life.
Before each use, check the hedge trim-
mer for obvious defects such as loose,
worn or damaged parts. Check the se-
cure seating of the bolts in the cutter bar.
Do not use the unit if the blades are
blunt or worn. This will overstress the
motor and gearbox of the machine.
Check coverings and safety devices
for damage and correct seating. Re-
place these where necessary.
58

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Parkside-PKGA-40-Li-A1---IAN-313870

Zoeken resetten

  • LS
    Ik heb een Parkside apparaat PKGA 40-LiA1.
    Ik ben op zoek naar de ronde dop die je op de spoel moet zetten. Met die dop moet je een tikje op de grond geven om de maaidraad te verlengen. Kunt u mij helpen? In de beschrijvingen staat deze dop waarschijnlijk onder nummer 17 maar ziet er toch anders uit dan wat ik bedoel. Waar kan ik zo'n dop bestellen in Nederland?
    mvg
    mw. Mulder - de Vree Gesteld op 10-11-2022 om 21:54

    Reageer op deze vraag Misbruik melden
  • Bevestiging van metalen onkruid maaier van accu maaier Gesteld op 8-11-2021 om 16:34

    Reageer op deze vraag Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Parkside PKGA 40-Li A1 - IAN 313870 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Parkside PKGA 40-Li A1 - IAN 313870 in de taal/talen: Nederlands, Duits, Engels, Frans, Pools als bijlage per email.

De handleiding is 5,14 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info