The hammer drill is not designed for outdoors
use as specified I Article 3 of Directive
2000/14/EC_2005/88/EC.
Wear ear-muffs.
The impact of noise can cause damage to
hearing.
Total vibration values (vector sum of three
directions) determined in accordance with EN
60745.
Hammer drilling in concrete
Vibration emission value a
h
= 15.81 m/s
2
K uncertainty = 1.5 m/s
2
Chiseling
Vibration emission value a
h
= 15.668 m/s
2
K uncertainty = 1.5 m/s
2
Warning!
The specified vibration value was established in
accordance with a standardized testing
method. It may change according to how the
electric equipment is used and may exceed the
specified value in exceptional circumstances.
The specified vibration value can be used to
compare the equipment with other electric
power tools.
The specified vibration value can be used for
initial assessment of a harmful effect.
Keep the noise emissions and vibrations to
a minimum.
Only use appliances which are in perfect
working order.
Service and clean the appliance regularly.
Adapt your working style to suit the
appliance.
Do not overload the appliance.
Have the appliance serviced whenever
necessary.
Switch the appliance off when it is not in
use.
Wear protective gloves.
7. Before starting the equipment
Important!
Before you connect the equipment to the
mains supply make sure that the data on the
rating plate are identical to the mains data.
Always pull the power plug before making
adjustments to the equipment.
Check the drilling point for concealed electrical
cables, gas and water pipes using a cable/pipe
detector.
7.1 Additional handle (Fig. 2 – Item 3)
For safety reasons you must only use the
hammer drill with the additional handle.
The additional handle (3) enables you to
achieve better stability whilst using the
equipment. Do not use the equipment without
the additional handle (3). The additional handle
(3) is secured to the equipment by a clamp.
Turning the additional handle (3) clockwise
tightens this clamp. Turning it anti-clockwise will
release the clamp.
The supplied additional handle (3) must first
be fitted. To do this, turn the additional
handle (3) until the clamp is opened wide
enough for you to slide the additional handle
(3) onto the equipment.
After you have mounted the additional
handle (3), swivel it to the most comfortable
working position for yourself.
Now turn the additional handle (3) in the
opposite direction again until the additional
handle (3) is secure.
The additional handle (3) is suitable for both
left-handed and right-handed users.
7.2 Depth stop (Fig. 3 – Item 13)
The depth stop (13) is held in place by
clamping with the locking screw (4) on the
additional handle (3).
Release the locking screw (4) and insert the
depth stop (13).
Set the depth stop (13) to the same level as
the drill bit.
Pull the depth stop (13) back by the
required drilling depth.
12
GB/
IE
