19
GB IE
combustible parts, including those in the
surroundings.
The device must only be
operated with the protective
hood mounted.
1. Open the tightening lever
(15).
2. Place the protective hood (17)
on the positioning holes.
3. Turn the protective hood (17) into
the working position. The closed
side of the protective hood must
always face the operator.
4. Close the tightening lever
(15) again. The protective hood
should not be able to be turned
any more.
If needed, the tension on the adjustment
nut (
21) can be set.
Installing/changing disc
Before initial operation,
check the tightness of the
clamping nut (19).
1. Press the spindle stop button (3).
2. Release the clamping nut
(
19) with the chuck key
(1).
3. Set the desired disc onto the
18). label
on the disc should always face
the device.
4. Set the clamping nut (
19) on
the mounting spindlel (
20)
-
ping nut must face the attach-
ment tool.
5.
Press the spindle stop button (3)
and pull the clamping nut (19)
tight again using the chuck key (1).
Operation
Caution! Risk of injury!
- Always remove the mains plug
before working on the tool.
- Only use grinding discs and acces-
sories recommended by the manu-
facturer. Using other attachment
tools and other accessories can
represent a risk of injury for you.
- Only use grinding tools which
bear information about the manu-
facturer, type of binding, dimen-
sion and permitted number of
revolutions.
- Only use grinding discs where
the printed rotational speed is at
least as high as what has been
device.
- Do not use any broken, cracked,
or otherwise damaged grinding
discs.
- Never operate the device without
protective equipment.
-
Large
workpieces may bend under their
own weight. The workpiece must
be supported on both sides of the
disc, near the cutting disc as well
as at the edge.
Keep your hands away from
the disc when the device is in
operation. Risk of injury.
