458602
67
Verklein
Vergroot
Pagina terug
1/175
Pagina verder
4 Operation
4-26 FrameSaver NP 110 Users Manual - Installation Guide 980-001-0240B
November
2000
Test
Installation
The final step of the FrameSaver NP 110 installation is to verify operations. This is
done through the Network Control Center (NCC).
1. Contact the Network Control Center and inform the Operator that the physical
installation and initial configuration are completed.
2. The NCC will establish a management session to the FrameSaver NP 110 and
complete any final/additional configuration, and review the systems status screens
to verify operation.
NOTE: To enable NCC management access, the local console session must be logged
out, and if the NCC is attempting a dial-in connection, the local terminal must also be
disconnected from the AUX 2 port.
If this installation is configured for Out-Of-Band Trap Reporting, a test of this feature
should also be performed. This is done by initiating a Network communications failure
which causes the FrameSaver NP 110 to issue a Trap Report to the Trap Manager. This
test must be coordinated with the NCC Operator to verify that the Trap Report is re-
ceived and that Network communications are restored after the test.
3. Coordinate the initiation of this test with the NCC Operator, and when told to do
so, disconnect the T1 Line from the FrameSaver NP 110. The FrameSaver NP 110
will dial-out to issue a Trap Report after approximately five (5) seconds. This can
be seen on the front panel by the MODEM IN USE LED going steady ON. After
the MODEM IN USE LED goes OFF, reconnect the T1 Line and confirm with
the NCC Operator that the Trap Report has been received, and that good
communications have been reestablished with the FrameSaver NP 110.
NOTE: If the NCC management session (Step # 2) was established via dial-in, this
must be terminated before the FrameSaver NP 110 can use the Modem to issue the
Trap Report.
This dial-out Trap Report test is highly recommended because it adds a greater level
of confidence to the completion of the installation process. This test verifies all of the
following, in addition to the normal operation of the FrameSaver NP 110:
Dial Line is operational and a call can be made (not inadvertently blocked).
Trap Manager phone number is correct.
IP Address is correct.
Trap Manager Address and Community are correct.
The installation and initial testing are now complete. If any results were other than
those described, refer to section 5, Diagnostics in this manual for assistance.
67

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Paradyne-FrameSaver-NP-110

Zoeken resetten

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Paradyne FrameSaver NP 110 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Paradyne FrameSaver NP 110 in de taal/talen: Engels als bijlage per email.

De handleiding is 1,17 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info