598890
108
Verklein
Vergroot
Pagina terug
1/129
Pagina verder
Monitor Lamp indicators
108
- ENGLISH
Maintenance
J
TEMP indicator
Lamp
indication
Information Check point Remedial measure
Lighting in red
Warm-up status
Did you turn on the power when
z
the ambient temperature was
lower than approx. 0 °C (32 °F)?
Wait about 5 minutes in the current
z
status.
Install the unit in a location having
z
an ambient temperature from 0 °C
(32 °F) - 45 °C (113 °F).
High temperature
inside. (WARNING)
Check the ventilation port is
z
blocked.
Is the room air temperature too
z
high?
Is the lter indicator lighted?
z
Remove the object that is blocking
z
the ventilation port.
Move the projector to a temperature
z
of 0 °C (32 °F) - 45 °C (113 °F) and
the humidity of 20 % to 80 % (no
condensation).
Turn off the MAIN POWER switch
z
using the procedure on page 40 and
replace the ACF unit.
Blinking in red
(once)
The lter is
excessively dirty
and the ventilation
is poor.
Blinking in red
(twice)
High temperature
inside.
(Standby condition)
Blinking in red
(3 times)
Cooling fan has
been stopped.
Turn off the MAIN POWER switch
z
using the procedure on page 40 and
consult the dealer.
Note
If no problem is found or the problem remains, do not turn on the projector. Instead contact your dealer.
z
J
FILTER indicator
Lamp
indication
Information Check point Remedial measure
Lighting in red
The ACF unit has
run out.
Check the [REMAINING
z
FILTER] of [STATUS] in
[PROJECTOR SETUP] menu.
(
Æ
page 83)
Replace the ACF unit.
z
Blinking in red
The ACF unit is not
installed.
Check the ACF unit
z
compartment.
Replace the ACF unit.
z
Lighting in
orange
The ACF unit
remains few. The
remaining use time
of the ACF unit is
approximately 200
hours.
Check the [REMAINING
z
FILTER] of [STATUS] in
[PROJECTOR SETUP] menu.
(
Æ
page 83)
Request the dealer to purchase the
z
new ACF unit.
Blinking in
orange
The ACF unit cannot
operate properly.
Is foreign object blocking the
z
ACF unit operation?
Remove the foreign object from the
z
ACF unit.
When the foreign object still
z
remained, contact the dealer.
Note
If no problem is found or the problem remains, do not turn on the projector. Instead contact your dealer.
z
When the ACF unit is not installed, the lter indicator will blink in red and the power will turn off in 10 minutes.
z
When the FILTER indicator is ashing green, the Auto Cleaning Filter (ACF) is normally rolling up.
z
When the ACF unit is operating, operational sound may be heard.
z
The usable time after lighting of the orange lamp may be shortened in a dusty environment. The time of about 200 hours is
z
for reference only. Contact the dealer to purchase the new ACF unit earlier.
If the projector is used at elevations higher than 1 400 m above sea level with the [HIGH ALTITUDE MODE] at [OFF], the
z
lamp life or life of other components will be shortened.
Before the FILTER indicator blinks in orange when operational malfunction, mechanical sound of the clutch may be heard.
z
If the Smoke Cut Filter is installed, the green lamp, which takes longer to turn ON/OFF, will ash.
z
If the lter is running low, only one lamp lights even if [DUAL] is selected. The lamps will light as normal once the lter has
z
been replaced and the residual lter has been reset.
108

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Panasonic PT-DS8500 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Panasonic PT-DS8500 in de taal/talen: Engels als bijlage per email.

De handleiding is 12,55 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info