58
Other Recording
1: Auto Focus Function does not work.
1-1: Is Manual Focus Mode selected? If Auto
Focus Mode is selected, focus is
automatically adjusted. (l 29)
1-2: There are some recording subjects and
recording surroundings for which the Auto
Focus Function does not operate correctly. In
this case, use the Manual Focus Mode to
adjust the focus. (l 59)
Editing
1: Audio dubbing cannot be performed.
1-1: Is the accidental erasure prevention slider on
the Cassette open? If it is open (set to
[SAVE]), recording cannot be performed.
(l 14)
1-2: Are you attempting to edit a tape portion that
was recorded in LP Mode? LP Mode does
not allow audio dubbing to operate. (l 21)
Indications
1: The Time Code becomes inaccurate.
1: The Time Code Indication counter may not
be constant in the reverse direction in Slow
Motion Playback Mode, but this is not a
malfunction.
2: The Remaining Tape Time Indication
disappears.
2: When you record still pictures in Photoshot
Mode, the Remaining Tape Time Indication
may disappear temporarily. However, it
reappears when recording normally.
3: The Remaining Tape Time Indication does
not match the actual remaining tape time.
3-1: If scenes of less than 15 seconds are
continuously recorded, the remaining tape
time cannot be displayed correctly.
3-2: In some cases, the Remaining Tape Time
Indication may show remaining tape time that
is 2 to 3 minutes shorter than the actual
remaining tape time.
Playback (Images)
1: Images cannot be played back even when
the [1] Button is pressed.
1: Is the [VCR/OFF/CAMERA/M-CARD] Switch
set to [VCR]? If it is set to the other position,
the playback function cannot be used. (l 32)
2: Mosaic-pattern noise appears on images
during Cue, Review or Slow Motion
Playback.
2: This phenomenon is characteristic of digital
video systems. It is not a malfunction.
3: Although the Movie Camera is correctly
connected to a TV, playback images
cannot be seen.
3: Have you selected “Video Input” on the TV?
Please read the operating instructions of your
TV and select the channel that matches the
input sockets used for the connection.
4: Playback image is not clear.
4: Are the heads of the Movie Camera dirty? If
the heads are dirty, playback image cannot
be clear. (l 55)
Playback (Sound)
1: Sound is not played back from the built-in
speaker of the Movie Camera or the
headphones.
1: Is the volume too low? Push the [VOLUME]
Lever to adjust the volume. (l 32)
2: Different sounds are reproduced at the
same time.
2: [12bit AUDIO] on the
[PLAYBACK FUNCTIONS] Sub-Menu of the
[VCR FUNCTIONS] Main-Menu has been set
to [MIX]. As a result, the original sound and
sound that was recorded by audio dubbing
are played back together. It is possible to
reproduce the sounds separately. (l 37)
3: The original sound was erased when
audio dubbing was performed.
3: If you perform audio dubbing on a recording
done in [16bit] Mode, the original sound will
be erased. If you wish to preserve the original
sound, be sure to select [12bit] Mode at the
time of recording.
4: Sounds cannot be played back.
4-1: Although a Cassette with no audio dubbing is
being played, is [12bit AUDIO] on the
[PLAYBACK FUNCTIONS] Sub-Menu of the
[VCR FUNCTIONS] Main-Menu set to [ST2]?
To play back a Cassette with no audio
dubbing, [12bit AUDIO] must be set to [ST1].
(l 37)
4-2: Is the Variable Speed Search Function
working? Press the [1] Button to cancel the
Variable Speed Search Function. (l 33)
Card (NV-DS65 only)
1: Card Photoshot Playback images do not
look normal.
1: The picture may be damaged. In order to
prevent the loss of image data, backing up on
a personal computer is recommended.
(l 39, 52)
2: Even if a Card is formatted, it cannot be
used.
2: Either the Movie Camera or the Card may be
damaged. Please consult a dealer.
B-Eng.book 58 ページ ２００３年２月１４日 金曜日 午後２時４３分
