Caution
After a high temperature wash, be
careful to not burn yourself when
handling the laundry or touching
the inside of the drum.
Note
If the detergent is not completely -
removed from the laundry by using
the basic programme, use the Extra
Rinse function.
If the load is big, the laundry may -
stick to the inside of the drum. This
is normal.
Leave the appliance door open -
to allow the drum to dry out after
removing the laundry.
Remove the laundry and rearrange -
where necessary. Do not leave it in
the drum too long after the programme
ends, because colours may run.
Required time
Times depend on the programmes and
temperature settings that have been
selected.
Actual times may differ slightly from -
those shown.
The displayed times include the time -
needed for the water to fill up and to
drain out, thus they vary depending on
water pressure, drainage and amount of
laundry.
If the laundry in the drum needs to be -
balanced, times will be extended.
Setting the buzzer
To turn on or turn off the buzzer which
sounds when the programme has finished,
follow these instructions.
Simultaneously press and hold the
Temperature and Time buttons for at
least 3 seconds.
The buzzer setting will be turned off after
a beep is heard.
The buzzer setting will be turned on after
two beeps are heard.
Changing settings while
washing
After washing has started, the programme,
temperature, preset time and Extra Rinse
function cannot be changed.
To change the programme, temperature,
preset time, or Extra Rinse function
settings, turn the appliance off and then on
again.
