2 MbN:
Select the desired categories. a
MSELECTN
R “
” is displayed next to the selected
c
ategory numbers.
R To cancel the selected category:
MbN: Select the category. a Press
MSELECTN again. “
” disappears.
3 MO
KN a MOFFN
Baby monitor
This feature allows you to listen in on a room
where another handset is located, allowing
you to easily monitor from different areas of
the house or place. The monitored handset
(placed in a baby’s room, for example) will
automatically call the monitoring handset or
the phone number stored when it detects
sound.
Important:
R You should perform a test run of the baby
monitor procedure to ensure that the baby
monitor feature is set correctly. For
example, test its sensitivity. Check the
connection if you are diverting the baby
monitor to an outside line.
R This feature should not be used as a
substitute for a medical or caregiver’s
supervision. It is the caregiver’s
responsibility to stay close enough to
handle any eventuality.
Note:
R Both the monitored and monitoring
handsets must select the same base unit in
order to use the baby monitor feature
(page 34).
R If the unit is connected to a PBX system,
you cannot set the baby monitor.
R During the monitoring mode, battery
consumption is faster than usual. We
recommend leaving the monitored handset
on the base unit or charger.
R The monitored handset never rings while it
is being monitored.
If the base unit is placed near the
monitored handset, we recommend turning
off the base unit ringer volume (page 27).
Setting the baby monitor
Perform the setting operation with the handset
to be monitored (for example, the handset
placed in a baby’s room).
To monitor with a handset
T
he internal baby monitor feature is available
between handsets in the same radio cell.
1 MMENUN#268
2 MbN: “On” a MOKN
3 MbN: Select the desired handset number
to monitor with. a MOKN
R “Baby Monitor” will be displayed.
R The registered handset name/number
is displayed.
Note:
R When this feature is on, another handset
can hear the monitored handset by making
an intercom call.
To monitor from an outside line
I
f you enable this feature, the unit will call a
pre-programmed phone number when the
handset detects sound. After you answer the
call, you can listen in on the room where the
handset is located.
n From the phonebook:
1 MMENUN#268
2 MbN: “On” a MOKN
3 MbN: Select “External” to monitor
from an outside line. a MEDITN a
MADDN
4 MbN: “Phonebook” a MOKN
5 MbN: Select the phonebook entry. a
MOKN
R “Baby Monitor” will be displayed.
Note:
R If you edit a phonebook entry which is
assigned for monitoring, the edited entry
does not transfer to the monitor.
n By entering phone numbers:
1 MMENUN#268
2 MbN: “On” a MOKN
Helpline Tel. No.: U.K. 0344 844 3899 Ireland 01289 8333
31
Programming
