628745
125
Verklein
Vergroot
Pagina terug
1/142
Pagina verder
5.1.3 Operation
PROBLEM PROBABLE CAUSE SOLUTION
Cannot set the IP
address, subnet mask
address, and PBX IP
address to the IP-PT.
An unusable value is
being set.
Set an IP address within the valid range.
IP address of the IP-PT/PBX: "1.0.0.0" to
"223.255.255.255
" Subnet mask address:
"0–255.0–255.0–255.0–255" (except
0.0.0.0 and 255.255.255.255)
Cannot register the
IP-PT.
The necessary network
parameters are not set
to the IP-PT.
When
not using a DHCP server, set the IP
address, subnet mask address, and enter
the PBX IP address. If necessary, also
enter the IP address of the default
gateway.
When using a DHCP server, enter the
PBX IP address.
The IP-PT cannot
connect to the PBX.
The wrong IP address,
subnet mask address,
PBX IP address, or
default gateway
address was entered.
Check each parameter and enter the
correct value.
The Ethernet cable is
not connected
correctly.
Check the Ethernet cable connections.
The
DHCP server is not
active.
Restart the DHCP server.
Disable DHCP and re-enter settings as
appropriate.
Whenever you try to
make calls using a SIP
Extension, a busy tone
is heard.
The status of the port
that the SIP Extension
is
connected to is Out of
Service.
Change the port status from Out of
Service to In Service using the
Maintenance Console.
When using the
speakerphone on an
APT,
nothing is audible.
The HANDSET/
HEADSET selector is
set to the "HEADSET"
position.
When the headset is not used, set the
HANDSET/HEADSET selector to the
"HANDSET" position.
When using the
speakerphone/monitor
mode with a DPT,
nothing is audible.
The "HEADSET" mode
is selected by Personal
Programming,
"Handset/Headset
Selection".
When the headset is not used, select the
"HANDSET" mode by Personal
Programming.
The PT does not ring. The
ringer volume is off. Turn on the ringer volume.
During a power failure,
extensions connected
to
port 1 of DHLC4 card
do not operate.
A DPT or APT is
connected to the
extension port.
The dialing mode (tone
or pulse) is incorrect.
Disconnect the DPT or APT and connect
an SLT.
Set the Tone/Pulse switch to the other
position.
Document Version 2011-10 Installation Manual 125
5.1.3 Operation
125

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Panasonic KX-NCP500 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Panasonic KX-NCP500 in de taal/talen: Engels als bijlage per email.

De handleiding is 2,93 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Panasonic KX-NCP500

Panasonic KX-NCP500 Gebruiksaanwijzing - Nederlands - 286 pagina's

Panasonic KX-NCP500 Gebruiksaanwijzing - Deutsch - 286 pagina's

Panasonic KX-NCP500 Gebruiksaanwijzing - English - 218 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info