Microphone
LED indicator
MH
IGHN/MLOWN
Used to change the sensor
sensitivity (page 17).
Rear cover
M N
Used to confirm the status of the
sensor or register the sensor to
the hub.
LED indicator
Y
ou can press M
N
and check the
LED indicator to confirm the sensor’s
status. After confirming the sensor’s
status, we recommend turning the LED
indicator off by pressing M
N
again
as soon as possible, otherwise battery
life may be reduced.
Indicator Status
Green, lit No glass break
d
etected
Red, lit Glass break was
d
etected
Red,
b
linking
Sensor is out of range
of the hub
Green,
b
linking
slowly
Registration mode
(You pressed and held
M
N)
Off No battery power
Note:
R T
he LED indicator does not indicate
sensor status if the sensor has not
been registered (page 10).
Setup overview
1 I
nitial setup
Make sure you can access the
system using your mobile device.
For details, refer to the System
Setup Guide included with your
hub.
2 Insert the batteries
The sensor is battery powered.
3 Registration
Required only if the sensor was
purchased separately (i.e., not as
part of a bundle).
4 Confirm the installation area
Read the information in this
document to confirm that the
desired installation area is suitable
to proper operation.
5 Installation
Install the sensor in the desired
location.
8
For a
ssistance, please visit http://shop.panasonic.com/support
Setup
