Attaching or removing
battery pack
1. To connect the battery pack:
Insert the battery pack. It snaps
into place to indicate proper con-
nection.
2. To remove the battery pack:
Press the two buttons on the sides
of the battery pack. Slide the bat-
tery pack out of the tool body.
Support handle
Place the support handle at your
favorite position and tighten the
handle securely.
Loosen Tighten
Remove the handle when placing the
tool in the storage case.
. OPERATION
Switch Operation
1. The speed increases with the
amount of depression of the trigger.
When beginning work, depress the
trigger slightly to start the rotation
slowly.
2. A feedback electronic controller is
used to give a strong torque even in
low speed.
3. The brake operates when the trig-
ger is released and the motor stops
immediately.
NOTE:
When the brake operates, a braking
sound may be heard. This is normal.
Forward/Reverse lever
Operation
(Forward ( ), Switch lock, Reverse ( ))
CAUTION:
Do not operate Forward/Reverse
lever until the chuck comes to a com-
plete stop. Shifting during rotation of
the chuck may damage the tool.
Forward Rotation Switch
Operation
1. Push the lever for forward rotation.
2. Depress the trigger switch slightly to
start the tool slowly.
3. The speed increases with the
amount of depression of the trigger
for efficient tightening of screws and
drilling. The brake operates and the
chuck stops immediately when the
trigger is released.
4. After use, set the lever to its center
position (switch lock).
Reverse Rotation Switch
Operation
1. Push the lever for reverse rotation.
Check the direction of rotation be-
fore use.
2. Depress the trigger switch slightly to
start the tool slowly.
3. After use, set the lever to its center
position (switch lock).
Clutch Torque Setting
Adjust the torque to one of the 15
possible settings or “ “ position to
the job.
CAUTION:
Test the setting before actual opera-
tion.
Set the scale at this mark (
).
