11) Be careful not to drop Wood Saw.
12) Never swing Wood Saw.
13) Never cover the ventilation slots, and keep
them free from dust or other material.
14) Do not clamp Wood Saw in a vise. Never cut
with Wood Saw held upside down in a vise.
This is extremely dangerous and can lead
to serious accidents.
15) Never wear knitted gloves.
16) Be sure no one is below when using Wood
Saw in high locations.
17) Do not touch the blade immediately after
operation. It may be hot and could burn
your skin.
18) Do not put fingers and foreign objects into
the dust collection duct.
19) Do not remove the lower guard. If the lower
guard is damaged or missing, return tool to
authorized service center for replacement.
20) Do not start the blade when in contact with
workpiece. Wait for blade to reach full speed
before beginning cut.
Blade for wood material
(EY9PW17A)
• Safe Working Practice
1.The maximum speed marked on the tool shall
not be exceeded. For the speed range, please
refer to Technical Specification.
2.Circular saw blades, the bodies of which are
cracked, shall be scrapped.
3.Composite (tipped) circular saw blades, where
the tip dimension is reduced to 1 mm, shall be
taken out of service. Refer to Figure 1.
4.Use of loose rings or bushes to "make up"
bore sizes on circular saw blades is not per-
mitted.
5.Repairing is not permitted.
1 mm
3.6 mm
Figure 1 Minimum dimension of composite
circular saw blade tips.
• Information
1.This circular saw blade complies with
European Norm EN 847-1:1997 + AC.
EY9PW17A
Technical Specification
Cutting diameter 165 mm
Bore diameter (H8) 20 mm
Number of teeth 48
Cutting width 1.5 mm
Body thickness 1.0 mm
Maximum speed 4500 min
-1
Material group HW
Symbol
Symbol
Meaning
V
Volts
Direct current
n
0
No load speed
··· / min
Revolutions or reciprocations
per minute
A
Amperes
III. SETTING UP
Charging Battery Pack EY9251
Charge the battery pack when the cutting speed
becomes too slow for effective cutting.
If you have two battery packs, you can use one to
continue working while charging the other one.
NOTE:
When you charge the battery pack for the first
time, or after prolonged storage, charge it for
about 24 hours to bring the battery up to full
capacity.
Battery charger (EY0110)
1. Plug the charger into the AC outlet.
NOTE:
Sparks may be produced when the plug is
inserted into the AC power supply, but this is
not a problem in terms of safety.
2. Insert the battery pack firmly into the charger.
Battery
pack
To AC
outlet
Battery
charger
1
2
3. During charging, the charging lamp will be lit.
