This unit ca
∫ About the recording quality setting
The recording quality for motion pictures can be changed in [Rec Quality] of the
[Motion Picture] menu.
• When recording to the built-in memory
• Motion pictures can be recorded continuously up to 2 GB.
The maximum available recording time for up to 2 GB only is displayed on the
∫ About
•
The Extended Optical Zoom and Intelligent Zoom cannot be used du
recording.
• If the Extended Optical Zoom
button, these settings will be cleared, so the recording range will change
The cam
and pl
with the
1 Press [
2 Press 3/ 4/ 2/ 1 to sel
∫ Close the menu
Press ] repe
•
In recording m
• There are functions that cannot be set or used depending on the
being used on the camera due to the specifications.
Recording M
[MODE] bu
Curso
• Press 3/ 4/ 2/ 1 to select the
and then press [MENU/SET].
• Y
Recording Mode.
(Motion pictures cannot be recorded in
Panorama Shot Mode.)
Motio
• The recording state indicator (red) will flash
while recording motion pictures.
• Stop the recording by pressing the motion
picture button again.
Settings Picture s fps Aspect ratio
[HD] 1280k 720
30
16:9
[VGA] 640k 480
4:3
[QVGA] 320k 240
Playback
[( ] (Pl
• Use this to play back pictures.
Curso
• 2/ 1: to select the picture
[ ] (Delete)
• [ ]: to delete the displayed picture
Setting the M
Menu Description of settings
[Rec]
The menu lets you set the Coloring, Sensitivity or Number of
pixels, etc. of pictures you are recording.
[Motion Picture]
This menu lets you set the setting for motion pictures such as
recording quality
[Playback]
This menu lets to the pictures taken. For
example, you c
[Setup]
This menu lets you perform the clock settings, beep tone
settings and other settings which make it easier for you to
operate the camera.
[Wi-Fi]
This menu lets you make the settings necessary to connect to
Wi-Fi or use the Wi-Fi function.
3 Press 3/ 4 to sel
[MENU/SET].
• It will switch to the next page when you reach the bottom.
(It will also switch by rotating the zoom lever)
4 Press 3/ 4 to sel
[MENU/SET].
• Depending on the menu item, its setting may no
may be displayed in a different way
100-0001100-0001100-0001
1/1/5
Cancel
Select
Set
AF Mode
AUTO
AWB
1/3
Rec
White Balance
Sensitivity
Picture Size
Select auto
focus
mode
Cancel
Select
Set
AF Mode
Face Detection
Focus detected
person’s face
The camera is not
¢ In this manual, the app is referred to as “
What you ca
®
function
Controllin
Recording images
remotely with a
smartphone
Playing back pictures
in the camera
Saving images stored
in the camera
Install the
¢
on your
smar
• OS
App for Android
TM
: Android 2.3.3 or higher
> Search the Google Play
TM
S
app.
App for iOS: iOS 5.0 or higher:
> Search the App Store
SM
for “
• Use the latest version.
• Some smartphones/tablets may not work correctly
refer to the support site below.
http://panasonic.jp/support/global/cs/dsc/
When
Sending an image each
time a recording is
made
Sending selected
images
Connecting to a
Using the Q
(If you are
R
/iP
R
/iPad
R
])
1 Press
• The QR code will be displayed on the camera screen.
2 Start “
3 Select
4 Using “ Image
camera.
5 Install the .
• A message will be displayed on the browser.
• If the smartphone/tablet is locked with a passcode,
enter the passcode to unlock the smartphone/tablet.
6 Press
7 T.
8
Select the SS
9 Retur
• Ste 2 through 6 are not required from the second time on.
Using the Q
(If yo
1 Press
• The QR code will be displayed on the camera screen.
2 On the
3 Select
4 Using “ Image
camera.
Cancel
SSID:
Password:
Please set on your smartphone
Change method
Please scan the QR code using "Image App",
or enter the password into Wi-Fi settings
IMAGE APP
Panasonic Corporation
Cancel
SSID:
Password:
Please set on your smartphone
Change method
Please scan the QR code using "Image App",
or enter the password into Wi-Fi settings
∫ Enteri
1 Press a
• The Password will be displayed on the camera screen.
2 T.
3 Sel
cam
4 Enter
cam
• If you are using an Android device, marking the box for
password display will allow the device to display the
password as you enter it.
5 On the s
∫ Reco
1 Connect
2 Select ]
• The recorded images are saved in the camera.
• Motion pictures cannot be recorded.
∫ Playing back the camera’
smartphone/tablet
1 Connect
2 Sel ]
• Images in the camera are
of the smartphone/tablet.
3 T
• Motion pictures cannot be played back.
∫ Saving the camera’
1 Connect
2 Select [ ] on the s
3 Press a
it on t
• Motion pictures cannot be saved.
∫
Sending lo
Y
• Read the [Help] in the “
T
• Create a PC user account [account name (up to 254 characters) and password (up to
32 characters)] consisting of alphanumeric characters.
An attempt to create a receive folder may fail if
(For W
Support
R
XP/Windows Vista
R
/Windows
R
7/Window
R
8/Wind
R
8.1
Example: W
1 Select a
2 Select [
• For details, refer to the operating instructions of your PC or Help on the OS.
(For M
Support
Example:
1 Select a
[File] > [
2 Enable sh
• For details, refer to the operating instructions of your PC or Help on the OS.
Y
The conne
connecti
Preparations:
• If the workgroup of the destination PC ha
need to change the setting of this unit in [PC Connection].
1 Press [
Controllin
Setting up a
Creating a destination folder for images
Sendi
Cancel
SSID:
Password:
Please set on your smartphone
Change method
Please scan the QR code using "Image App",
or enter the password into Wi-Fi settings
2 Press3/ 4/ 2/ 1 to
3 Press3/ 4 to select
4 Press3/ 4 to se
5 Select
6 On the
• When the PC you want to connect to is not displayed, select [Manual In
the computer name of the PC (NetBIOS name for Apple Mac computers).
• Folders sorted by the sent date are created in the specified fold
those folders.
• If the screen for a user account and password entry appears, enter the one you set o
PC.
• When the computer name (NetBIOS name for Apple Mac computers)
(blank character), etc., it may not be recognized correctly
recommend that you change the computer name (or NetBIOS
only alphanumeric characters, with a maximum of 15 characters.
1 Connec
(supp
2 Press3/ 4 to se
3 Drag an
• When the image transfer is complete, disconnect the USB connection cab
∫ Playba
Software for image playback or editing is not supplied with this product.
• T
• T
Sending an image each time you record it ([Send Images
While Recording])
Available file format: JPEG
Sending selected images ([Send Images Stored in the
Camera])
Available file format: JPEG/Motion JPEG
Example: Selecting [WPS (Push-Button)] to set up a connection
1 Select [Via Network].
2 Select [WP
3 Press an
access point until it switc
(Example)
[Send Images While Recording]
1 Select th
2 T
[Send Images Stored in the Camera]
1 Select th
2 Select [SING
T
cable (supplied
Cancel
Select
Set
Select a function
Remote Shooting & View
Send Images While Recording
Send Images Stored in the Camera
Cancel
Select
Set
Select connection method
Via Ne
Direct
Connect to the
network (AP)
USB Connection Cable
[A
• This socket is also used when charging
the battery
PC
• This phenomenon occurs when charging in a location where the temperature is very hig
very low
> Reconnect the USB connection cable (supplied) in a location where
temperature (and the temperature of battery) is in a 10 o C to 30 o C (50 o F to 86 oF)
range, and try charging again.
• This is a characteristic of CCDs, and it appears when the subject has a bright part. Some
unevenness may occur in the surrounding areas, but this is not a malfunction.
It is recorded in motion pictures but is not recorded on still pictures.
• It is recommended that when you take pictures you take care not to expose the screen to
sunlight or any other source of strong light.
(Gen
• Use within the communication range of the device to be connected.
• Is any device, such as microwave oven, cordless phone, etc., that uses 2.4 GHz freq
operated nearby?
> Radio waves may get interrupted when used simultaneously
from the device.
• When the battery indicator is flash
or the connection may be disrupted.
(A message such as [Communication error] is displayed.)
(About a
• Check if the wireless access point to connect is in operating state.
• The camera may not display or connect to a wireless access point depending on the
wave condition.
– Move this unit closer to the wireles
– Remove the obstacles between this unit and the wireless
– Change the direction of this un
– Change the location and orie
– Perform the [From List].
• It may not display even if the radio waves exist depending on the setting of the
access point.
> Check the settings of the wireless access point.
> When the network SSID of the
access point may not be detected. Enter the network SSID to start the connection or
enable the SSID broadcast of the wireless access point.
• Connection types and security setting methods are different depending on the wireless
access point. (Refer to the operating instructions of the wireless access point.)
• Is the 5 GHz/2.4 GHz switchable wireless access point connected to other equipment u
the 5 GHz band?
> The use of a wireless access point that can use 5 GHz/2.4 GHz simultaneously is
recommended. It cannot be used simultaneously with this camera if it is not compatible.
• It may take longer time to connect depending on the Wi-Fi connection setting of the
smartphone/tablet, but it is not a malfunction.
• Is the size of the image too large?
> Reduce the size of the still picture, then transmit.
> Image cannot be transmitted when the battery indicator is flashing re
Please r
S
Digital Camera: Informat
T
If the problem is not resolved, it may be improved by selecting [Reset] on the [Setu
menu.
The charging lamp blinks.
When recording pictures or half-pressing the shutter button, reddish stripes may
appear on the monitor
color
A Wi-Fi
Radio w
Wireless
It takes long
T
S
Power Source: DC 5 V
Power Consumption: 1.4 W (When recording)
0.8 W (When playing
Camera effective
pixels
16,000,000 pixels
Image sensor 1/2.33q CCD sensor, tot
Primary color filter
Lens Optical 12 k zoom, f l4.3 mm to 51.6 mm (35 mm film camera
equivalent: 24 mm to 288 mm)/F3.1 (Wide) to F6.3 (T
Image stabilizer Optical method
Focus range Normal/
Intelligent auto/
Motion picture
3 cm (0.098 feet) (Wide)/1.5 m (4.9 feet)
(T¶
Scene Mode There may be differences in the above
settings.
Wir
AC Adapto
Informat
Batte
Informat
This product incorporates the following software:
(1) the software developed independently by or for Panason
(2) the software owned by third party and licensed to Panasonic Corporation and/or,
(3) open source software
The software categorized as (3) is distributed in the hope that it will be useful, but WITHOUT
ANY WARRANTY
FOR A P
Please refer to the detailed terms and conditions thereof displayed by selecting [MENU/SET]
> [Setup] > [V> [MENU/SET].
• SDXC Logo is a trademark of SD-3C, LLC.
• QuickTime and the QuickT
trademarks of Apple Inc., used under license therefrom.
• Mac and Mac OS are trademarks of Apple Inc., registered in the
U.S. and other countries.
• iPad, iPhone, iPod, and iPod touch are trademarks of Apple Inc.,
registered in the U.S. and other countries.
• Windows and Windows Vista are either registered trademarks or
trademarks of Microsoft Corporation in the United States and/or
other countries.
• App Store is a service mark of Apple Inc.
• Android and Google Play are trademarks or registered
trademarks of Google Inc.
• The Wi-Fi CERTIFIED Logo is a certification mark of the Wi-Fi
Alliance.
• The Wi-Fi Protected Setup Mark is a mark of the Wi-Fi Alliance.
• “Wi-Fi”, “Wi-Fi Protected Setup”, “WP
registered marks of the Wi-Fi Alliance.
• QR Code is a registered trademark of DENSO WA
INCORPORA
Shutter system Electronic shutteri Mechanical shutter
Shutter speed 8 seconds to 1/2000th of a second
[S
Exposure (AE) Auto (Program AE)
Metering mode Multiple
Monitor 3.0q TFT LCD (4:3)
(Approx. 460,000 dots) (field of view ratio about 100%)
Microphone Monaural
Speaker Monaural
Recording media Built-in Memory (Approx. 80 MB)/SD Memory Card/SDHC
Memory Card/SDXC Memory Card
Recording file format
Still Picture JPEG (based on “Design
“Exif 2.3” standard)
Motion pictures QuickTime Motion JPEG
Interface
Digital “USB 2.0” (High Speed)
Analog video NTSC
Audio Audio line output (monaural)
T
[A Dedicated jack (8 pin)
Dimensions
(excluding the
projecting part
Approx. 99.8 mm (W)k 60.4 mm (H) k26.5 mm (D)
[3.93q
(W)
k2.38 q
(H)
k1.04 q
(D)]
Mass (weight) Approx. 159 g/0.35 lb (with card and battery)
Approx. 144 g /0.32 lb (excluding card and battery)
Operating temperature 0 o C to 40 o C (32 o F to 104 o F)
Operating humidity 10%RH to 80%RH
Language select
[ENGLISH]/[ESP
Compliance standard IEEE 802.1
Frequency range used
(central frequency)
2412 MHz to 2462 MHz (1 to 1
Encryption method Wi-Fi compliant WP
TM
/WP
TM
Access method Infrastructure mode
Input: 110 V to 240 V Hz, 0.2 A
Output: 5 V
V 3.6 V/690 mAh
VQT5G45~P_eng.fm 2 ペー
