Chapter 5 Preparation
60
5-1-2 Using an AC power supply
When the AJ-B75 AC adapter made by Panasonic is
used
1
Connect the DC OUT connector on the AJ-B75 AC
adapter to the DC IN socket on the unit.
2
Set the power of the AC adapter to ON.
3
Set the unit’s power switch to ON.
When using an external power supply other than the AJ-
B75 AC adapter, check the pin signals of its external DC
input connector and use the polarities correctly.
Supplying +12V power to the GND terminal by mistake
may give rise to ignition, resulting in a fire, or it may cause
injury.
<Notes>
≥Power from the AC adapter takes precedence when
both a battery pack and AC adapter have been
connected. It is also possible to attach/remove a
battery while the AC adapter is being used.
≥When using the AC adapter, be absolutely sure to first
set the power of the AC adapter to ON and then set the
unit’s power switch to ON.
If the power is turned on in the reverse sequence, the
output voltage of the AC adapter will rise gradually, and
the unit may malfunction as a result.
Pin no. Signal
1 GND
2, 3 –
4 +12V
External DC input socket
DC IN socket
AC adapter
AJ-B75 (optional accessory)
5-2 Attaching the viewfinder and
adjusting its position
Refer to the instructions accompanying the viewfinder.
A slide rail is required for attaching a viewfinder (AJ-VF15 or
AJ-VF20W) other than the AJ-VF15B or AJ-VF20WB.
O If you wish to install the slide rail, ask your dealer to obtain
it as an accessory part.
Slide rail (VFC3995) . . . . . . . . . . . .1
Attachment screw (XSB3+8VZ) . . .2
How to install the slide rails
1
Remove the two screws on the top of the AJ-VF15 or AJ-
VF20W, and remove the mounting unit.
Leave the screws attached to the mounting unit.
2
Install the slide rail by screwing it into place using the two
screws that come with the rail.
Mounting unit
Screws
Slide rail
