597931
76
Verklein
Vergroot
Pagina terug
1/82
Pagina verder
76
Before calling for service (cont.)
Playback (sound)
Other
I can’t hear any sound
from the camera-
recorder’s speaker.
Have you turned down the camera-recorder’s volume control too
far?
In the VCR mode, adjust the volume level using the multi dial.
P44
I can hear two sets of
sound.
Have you selected “MIX” as the 32K (12bit) AUDIO item setting on
the PLAYBACK FUNCTION screen?
If you perform audio dubbing on a tape that was recorded with “32K
(12bit)” selected as the AUDIO REC item setting on the RECORD-
ING SETUP screen, you will hear the sound heard during recording
and that of the audio dubbing.
P67
P69
When I performed audio
dubbing on an existing
recording, the original
sound was erased.
If you perform audio dubbing on a tape that was recorded with “48K
(16bit)” selected as the AUDIO REC item setting on the RECORD-
ING SETUP screen, you will erase the original sound on the tape.
To leave the original sound intact, make sure that “32K (12bit)” is
selected as the item setting when you shoot the original recording.
P69
I can’t remove the cas-
sette tape.
Is power still being supplied to the camera-recorder? (Is the power
from the AC adapter and battery supplied properly?)
So long as the power is supplied, you can remove the cassette
even if the POWER lever is at the OFF position.
–––
I can remove the cassette
but I can’t perform any
other operations.
Has condensation formed?
If it forms, the only operation you can perform is to remove the cas-
sette. Wait until the condensation has dried out.
If the cassette cover is closed immediately after sliding the EJECT
switch to open the cassette cover, you may no longer be able to
perform any operations other than eject. If you did this, slide the
EJECT switch again to open the cassette cover, check that the cas-
sette mechanism has finished ejecting the cassette, and then close
the cassette cover.
P77
–––
The remote control unit
does not work.
Has the button battery in the remote control unit run out?
If the remote control fails to work even when it is operated near the
camera-recorder’s remote control sensor, it means that the button
battery has run out. Replace it with a new one.
Is the remote control setting the same for the remote control unit
and the camera-recorder?
If the REMOTE item setting does not correspond between the two
units, the remote control unit will not work.
P19
P19, 72
I hear a rattling sound
when I tilt the camera-
recorder back and forth.
There are some parts in the structure of the camera unit that make
a rattling sound in the VCR mode or when the POWER lever is at
the OFF position. This is not a sign that something is broken.
–––
76

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Panasonic AG-DVC 60p bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Panasonic AG-DVC 60p in de taal/talen: Engels als bijlage per email.

De handleiding is 2,49 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info