553769
7
Verklein
Vergroot
Pagina terug
1/97
Pagina verder
7
Before Using the TX-NR801/TX-NR801E
The worldwide model has a voltage selector for com-
patibility with power systems around the world. Before
you plug in this model, make sure that the voltage selec-
tor is set to the correct voltage for your area. If it isn’t,
use a small screwdriver to set it appropriately. For
example, if the voltage in your area is 120 volts (V), set
the selector to “120V.And if it’s between 220 and 230
volts (V), set it to “220-230V.
Notes:
The supplied batteries should last for about six
months, although this will vary with usage.
If the remote controller doesn’t work reliably, try
replacing both batteries.
Don’t mix new and old batteries, or different types of
batteries.
If you intend not to use the remote controller for a
long time, remove the batteries to prevent possible
leakage and corrosion.
Dead batteries should be removed as soon as possible
to prevent possible leakage and corrosion.
To use the remote controller, point it at the TX-NR801/
TX-NR801E’s remote control sensor, as shown below.
The TX-NR801/TX-NR801E’s STANDBY indicator
flashes while a signal is being received from the remote
controller.
Notes:
The remote controller may not work reliably if the
TX-NR801/TX-NR801E is subjected to bright light,
such as direct sunlight or inverter-type fluorescent
lights. Keep this in mind when installing the
TX-NR801/TX-NR801E.
If another remote controller of the same type is used
in the same room, or the TX-NR801/TX-NR801E is
installed close to equipment that uses infrared rays,
the remote controller may not work reliably.
Don’t put anything, such as a book, on the remote
controller, because the buttons may be pressed inad-
vertently, thereby draining the batteries.
The remote controller may not work reliably if the
TX-NR801/TX-NR801E is installed in a rack behind
colored glass doors. Keep this in mind when install-
ing the TX-NR801/TX-NR801E.
The remote controller will not work if there’s an
obstacle between it and the TX-NR801/
TX-NR801E’s remote control sensor.
Setting the Voltage Selector
(Worldwide model only)
Installing the Batteries
1
Remove the battery compartment cover
by pressing it and sliding it in the direc-
tion shown by the arrow below.
2
Insert the two supplied batteries (AA/R6)
in accordance with the polarity diagram
inside the battery compartment.
3
After the batteries are installed and
seated correctly, replace the compart-
ment cover .
SURR
BACK/
ZONE 2
SPEAKERS
AUDIO
VIDEO
S VIDEO
MONITOR
OUT
R
L
IN
IN
IN
IN
IN
ZONE 2
DVD
VIDEO 1
VIDEO 2
VIDEO 3
VIDEO 4
AUDIO
VIDEO
S VIDEO
COMPONENT
VIDEO
Y
P
B
PR
OUTPUT
INPUT 1
Y
P
B
PR
INPUT 2
Y
P
B
PR
FRONT SPEAKERS
L
RL
R
SURR SPEAKERS
CENTER
SPEAKER
R
L
R
L
OUT
OUT
OUT
I
R
IN
OUT
REMOTE
CONTROL
PHONO
DIGITAL
IN
PRE OUT
DIGITAL
OUT
OPT
OPT
2
1
2
1
2
3
FRONT
SUB
SURR
R
L
AUDIO
R
L
CD
TAPE
R
L
AUDIO
1
3
GND
SURR
BACK/
ZONE 2
IN
OUT
COAX
R
L
MULTI
CH
INPUT
FRONT
SUB
SURR
SURR
BACK
CENTER
R
L
R
L
AM
FM
75
CENTER
ANTENNA
IN
IN
(
Net
-
Tune
)
ETHERNET
4 OHMS MIN. OR
6 OHMS MIN.
/SPEAKER
CAUTION
:
SPEAKER
IMPEDANCE
SEE INSTRUCTION
MANUAL FOR
CORRECT SETTINGS.
AV RECEIVER
MODEL NO. TX
-
NR
801
VOLTAGE
SELECTOR
220
-
230V
120V
AC
OUTLETS
AC 230
-
240
V 50
Hz
SWITCHED
TOTAL 100
W MAX.
120V
VOLTAGE
SELECTOR
220-230V
Using the Remote Controller
30˚
30˚
Approx. 16 ft. (5 m)
Remote control sensor
Standby indicator
TX-NR801/TX-NR801E
7

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Onkyo TX-NR801 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Onkyo TX-NR801 in de taal/talen: Engels als bijlage per email.

De handleiding is 5,3 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info