492661
90
Verklein
Vergroot
Pagina terug
1/168
Pagina verder
Advanced Operations
En-90
Muting Zones
Operating on the remote controller
Tip
To unmute, press ZONE followed by MUTING again. Zones can
also be unmuted by adjusting the volume.
Note
ZONE 2 LINE OUT and FRONT WIDE/ZONE 2 L/R output
2ch PCM and analog input sources. To listen to the PCM source,
you need to make an HDMI connection ( page 21). If no
sound is heard when an input source is selected, check if the
source is connected to an analog input and HDMI input.
Only analog input sources are output by the ZONE 3 LINE OUT
and FRONT HIGH/ZONE 3 L/R terminals. Digital input
sources are not output. If no sound is heard when an input source
is selected, verify that the source is connected to an analog input.
(North American models) You can select different radio
stations for the main room and Zone 2 by connecting the supplied
antennas respectively ( page 24).
(North American models) When the main room and Zone 2
share the same input source, if the input selector of the main room
is TUNER, you cannot select different radio stations for the main
room and Zone 2 respectively.
(European models) You cannot select different AM or FM radio
stations for your main room and Zone 2/3. The same AM/FM
radio station will be heard in each room. Namely, if you have
selected an FM station for the main room, that station will also be
output in Zone 2/3.
You cannot select different radio stations for Zone 2 and Zone 3
respectively.
If Zone 2 and the main room share the same input source, only an
analog input signal is output.
If an HDMI component selected in Zone 2 outputs the sound
other than PCM, the sound is not output from FRONT
WIDE/ZONE 2 and ZONE 2 LINE OUT.
Both audio and video outputs from an HDMI component may
interrupt when the main room and Zone 2 are set to share the
same source or not.
When you have selected NET or USB as input selector, the last
selector selected will be set for Main room and Zone 2/3.
When Zone 2/3 is activated and its input selector is selected, the
power consumption of standby mode slightly increases.
While Zone 2/3 is on, u functions will not work.
The component connected to HDMI input other than HDMI IN
1/2/3/AUX INPUT is selected as an input source for Zone 2, the
linked operations of p may not work properly. In this
case, set the linked operations to Off on the source component.
When setting the AV receiver to standby mode while Zone 2/3 is
active, the Z2 or Z3 indicator is dimly lit.
Activating Zones in the main room when the listening mode is set
to Pure Audio will automatically switch it to Direct.
•“GAME2” cannot be selected as input sources for Zone 3.
When “GAME2” is the input source of Main room and Zone 3 is
set to share the same source, no sound will be output from Zone 3.
Even if you repeatedly press the remote controller’s ZONE to
select zones, the last zone selection will be retained once you
have switched to other components by pressing other REMOTE
MODE after pressing ZONE.
To control the AV receiver with the remote controller
while you’re in Zone, you’ll need a commercially available
multiroom remote control kit for each zone.
Multiroom kits are made by Niles and Xantech.
These kits can also be used when there isn’t a clear line of
sight to the AV receiver’s remote sensor, such as when it’s
installed inside a cabinet.
Using a Multiroom Kit with Zone
In this setup, the IR receiver in Zone picks up the infrared
signals from the remote controller and feeds them through
to the AV receiver in the main room via the connecting
block.
The miniplug cable from the connecting block should be
connected to the AV receiver’s IR IN jack, as shown
below.
1
Press ZONE repeatedly, and then press MUTING.
Using the Remote Controller in
Zone and Multiroom Control Kits
IR IN
Connecting
block
Remote controller
IR
receiver
Main room Zone
Signal flow
90

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Onkyo TX-NR3010 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Onkyo TX-NR3010 in de taal/talen: Engels als bijlage per email.

De handleiding is 4,85 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Onkyo TX-NR3010

Onkyo TX-NR3010 Gebruiksaanwijzing - Nederlands - 168 pagina's

Onkyo TX-NR3010 Gebruiksaanwijzing - Deutsch - 168 pagina's

Onkyo TX-NR3010 Gebruiksaanwijzing - Français - 168 pagina's

Onkyo TX-NR3010 Gebruiksaanwijzing - Italiano - 168 pagina's

Onkyo TX-NR3010 Gebruiksaanwijzing - Espanõl - 168 pagina's

Onkyo TX-NR3010 Gebruiksaanwijzing - Svenska - 168 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info