778490
21
Verklein
Vergroot
Pagina terug
1/64
Pagina verder
21
EN
INSTALLATION
1. Remove the appliance from the packaging and make sure that all accessories
(incl. ice basket and ice spoon) are included. Contact the costumer service if any
accessories are missing.
2. Make sure that the appliance is level and placed on a stable table or work surface
to avoid malfunctions.
3. The incline angle of the ice cube maker cabinet should not exceed 45° during
transportation or use. Do not turn the appliance upside down as this could damage
the compressor or the cooling system. After moving or transporting the appliance,
leave it unused for some time to allow the liquids in the compressor to settle. Wait at
least 2 hours before using the appliance for the rst time and after you have placed
it in the appropriate location and aligned it correctly.
4. Place the appliance in an adequately ventilated place on a dry and level surface.
Do not use the appliance near heat sources such as stoves, heaters or corrosive
gases. Keep a minimum distance of 20cm to all sides of the ice cube maker to
ensure proper ventilation.
5. Do not ll the water reservoir with hot water as this may damage the appliance. It is
best to ll the water reservoir with water that is at room temperature or cooler.
6. Do not use the appliance at a very cold environment (lower than 5 °C).
7. Clean the appliance before use (see section “Cleaning and Maintenance“).
COMMISSIONING AND OPERATION
1. Ensure that the drain plug at the bottom of water reservoir is closed well.
2. Plug the ice cube maker into the wall outlet, the ice making indicator lights
solidly.
Note: If the appliance has been moved, allow the ice cube maker to rest for
30minutes before plugging the power plug into the wall outlet.
3. Open the top lid and remove the ice basket.
4. Fill the water reservoir with drinking water.
Note: Do not ll above the MAX water level mark.
5. Replace the ice basket and close the top lid.
6. Press the ON/OFF button and the ice making indicator blinks.
7. The ice-making cycle will last approximately 7-15 minutes, depending on the
ambient temperature and water temperature.
8. The ice-making cycle starts with water being pumped into the ice tray situated
below the evaporator. Over the next 7-15 minutes ice forms on the evaporator.
Once this has completed, the ice tray will tilt backwards and the remaining water in
the ice tray is drained back into the water reservoir. The ice cubes are then dropped
from the evaporator and pushed forward into the ice basket by the ice shovel.
21

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw OneConcept 10035713 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van OneConcept 10035713 in de taal/talen: Duits, Engels, Frans, Italiaans, Spaans als bijlage per email.

De handleiding is 2.91 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info