12 WWW.ONEFORALL.COM
Device Sleeptimer
If your TV or Satellite has a “Sleeptimer” function built in, you can access
this function with your ONE FOR ALL remote. To do so:
1 Make sure your TV (or Satellite) is switched on.
2 Press the device key (TV or SAT).
3 Point the ONE FOR ALL at your TV (or Satellite) and press and relea-
se MAGIC then press POWER. You should see the Sleeptimer activa-
te on your TV screen.
To increase the timer, simply press POWER again (within 5 seconds)
until the timer gets to the desired time.
To deactivate the Sleeptimer, repeat steps 1-3 above. During step 3, continue
pressing POWER (within 5 seconds) until the timer indicates zero minutes.
ONE FOR ALL Sleeptimer
If your device does not have a sleeptimer function built in, you can install
the ONE FOR ALL sleeptimer function. To do so:
1 Press the device key (TV, SAT, CD or AUD).
2 Then, press and hold MAGIC until the device key blinks twice.
3 Press 970. The device key will blink twice again. It is only necessary
to perform steps 1, 2 and 3 once. Now to set the timer, continue
with the steps below.
Setting the ONE FOR ALL Sleeptimer:
It is possible to set the timer for 15, 30, 45 or 60 minutes. To do this, first
make sure your device is switched on.
Press the device key (TV, SAT, CD or AUD).
Now, press and release MAGIC then press POWER.
The device key will blink once which indicates the timer is
set for 15 minutes. To increase the timer, simply press
POWER again (this must be done within 5 seconds). The
device key will blink twice indicating the timer is set for 30
minutes (2x 15). You can press POWER to a maximum of
four times which will set the timer to 60 minutes.
Once you have set the timer to the desired time, set your ONE FOR ALL
remote down, pointing it at your device. When the programmed amount
of time has elapsed, the ONE FOR ALL will send the command for POWER,
hence turning off your device.
Important note: Depending on how you used sleeptimer on the original
remote, you might need to access sleeptimer in a different way (through
menu for example).
Important notes:
- The device key on the ONE FOR ALL will blink every 15 seconds indicating
that the remote is in Sleeptimer mode.
- To deactivate the Sleeptimer, simply press any key on the ONE FOR ALL
remote.
- Also, it is only necessary to follow steps 1,2 and 3 above once. For subse-
quent use of the Sleeptimer, simply begin with “Setting the Sleeptimer”.
- To switch the ONE FOR ALL back to Device Sleeptimer, repeat steps 1,2 and
3 above. The device key will blink 4 times.
- Remember, when using the ONE FOR ALL Sleeptimer, you must set the
remote so it is pointing to your device.
- The ONE FOR ALL Sleeptimer can be set up for only one device at a time.
(:15)
(:30)
(:45)
(:60)
