8
• Certain device codes are not learnable including multi-
frequency types, some high frequency ones, and other unusual
formats.
• For optimum learning, avoid high levels of ambient light such as
natural sunlight or energy-efficient fluorescent lights.
NOTE: Please have your original remote controls handy before
programming learning. Be sure to press each teaching key within
5 seconds of the previous entry. Otherwise, this remote exits the
learning mode.
Programming A Learning Key
1. Press and hold SET until the LED (red light) blinks twice, then
release SET.
2. Enter 9 7 5. The LED will blink twice.
3. Press a device key once (e.g., TV) to assign a mode for learning.
4. Press the desired key once (e.g., +100) to store a feature to be
learned. The LED will turn on and remain on for 5 seconds. If
the LED does not turn on, go back to step 1 and start again.
5. Place your original remote control (e.g., TV remote control)
head-to-head (about 2” apart) from this remote.
6. On your original remote control, press and hold the key (i.e.,
feature) to be learned until the LED on this remote turns off
and then blinks twice. If the LED does not blink twice, repeat
steps 3 through 6.
7. To learn functions onto other learning keys (e.g., M1 and M2),
repeat steps 3 through 6.
8. To lock in new feature(s) on this remote, press and hold SET
until the LED blinks twice, then release SET.
9. To test a learned feature, press a device key (e.g., TV) once
where the learning mode was assigned. Then press the learning
key (e.g., +100) where the learned feature is stored.
Deleting Functions From The Learning Keys
1. Press and hold SET until the LED (red light) blinks twice, then
release SET.
2. Enter 9 7 6. The LED will blink twice.
3. Press the device key once where the learned feature is stored
(e.g., TV).
4. Press the learning key (e.g., +100) to be deleted twice. The LED
will blink twice after the second press.
5. To clear additional functions stored on other learning keys,
repeat steps 1 through 4 (in this section).
Changing Volume Lock
This remote is set at the factory for independent volume control of
each selected device.
However, you may change the Volume Lock setting to Global
Volume Lock so that a device’s volume will be locked to one mode
(e.g., to control TV volume in all other modes). After that, if
desired, you can perform Individual Volume Unlock on a selected
device to set its volume control for independent operation.
Locking Volume Control To One Mode
(Global Volume Lock)
1. Press and hold SET until the LED (red light) blinks twice, then
release SET.
