8 WWW.ONEFORALL.COM
Search Method
If your Television, VCR, Satellite or Cable Converter does not respond to the
ZAPPER after trying all the codes listed for your brand, try searching for
your code. The Searching Method allows you to find the code of your devi-
ce by scanning through all the codes contained in the memory of the ONE
FOR ALL remote control. To search for your TV code:
1 Make sure that your Television is switched on (not in
standby).
2 Press the TV key on the ZAPPER.
3 Press and hold down MAGIC until the red light blinks
twice (it will blink once then twice).
4 Next, press the Programme(-) key three times.
5 Next, slowly alternate between TV and POWER until your
Television turns off. You may have to press these keys
many times, so be patient. Remember, you must aim the
ZAPPER at your device the entire time you are searching
for your code.
6 When your device turns off, press and release MAGIC, to
store the code.
The zapper should now be ready to operate your television. Turn your tele-
vision back on and try all the remote’s functions to ensure they are wor-
king properly. If some of the ZAPPER’S commands are not operating cor-
rectly, try the search method again, you may be using the wrong code.
Important notes:
- To search for the code for your VCR, Satellite Receiver or Cable Converter,
follow the same instructions above, only press the VCR or SAT key during
step 2 and 5.
- If your Video’s original remote control does not have a power key, press
PLAY instead of POWER when searching for your code.
- During step 5, you may have to press these keys many times (up to 150!),
so be patient. Remember, you must aim the ZAPPER at your device the
entire time you are searching for your code.
