589209
16
Verklein
Vergroot
Pagina terug
1/53
Pagina verder
16 17
<Checking the battery power>
1. Tu rn the camera on and then press the Power button to
turn the Ring Flash on.
•The [RING] indicator appears on the control panel and
battery charging starts.
Notes:
If the [RING] or [TWIN] indicator on the control panel
blinks, wait until the blinking stops, then turn the camera
off and re-connect the Ring Flash to the Ring Flash con-
nector (page 47).
• Both Twin Flash connectors must be capped or the Ring Flash
will not turn when the Power button is pressed.
2. Ensure that the Charge lamp lights up.
Replace the batteries if the time taken for the Charge lamp
to light up is longer than the values specified below.
Alkaline, Ni-Mn, lithium or
Ni-Cd batteries
If the Charge lamp and AUTO CHECK lamp blink alter-
nately, it means that the battery capacity is running low. In
this case, replace the batteries.
Memo: Test flash activation
To perform test flash activation, press the Test button.
3. Press the Power button again to turn the Ring Flash off.
Turn the Ring Flash off in the following cases:
Before mounting it on the camera or dismounting it from
the camera.
When flash emission is not required.
When not using the Ring Flash.
When plugging or unplugging the Ring Flash connector.
Flash Interval and Flash Count
The following table shows the flash intervals and flash counts for various batteries. Data is
based on using batteries all of the same type.
Batteries used
AA (R6) alkaline dry cell batteries (LR6 type)
AA (R6) Ni-Cd batteries, 1000 mAh
AA (R6) Ni-Mh batteries, 1900 mAh
AA (R6) Ni-Mn batteries (ZR6 type)
AA (R6) lithium batteries (FR6 type)
Lithium battery packs (CR-V3)
Flash interval
Approx. 4 sec.
Approx. 3 sec.
Approx. 3.5 sec.
Approx. 4 sec.
Approx. 5 sec.
Approx. 4 sec.
Flash count
Approx. 250 times
Approx. 170 times
Approx. 200 times
Approx. 160 times
Approx. 190 times
Approx. 420 times
* The flash emission interval and count data were obtained from in-house tests at Olympus.
MACRO FLASH CONTROLLER
FC-1
MODE
LAMP
AUTO
CHECK
TEST/
CHARGE
POWER
LIGHT
RATIO GN/
MACRO FLASH CONTROLLER
FC-1
MODE
LAMP
AUTO
CHECK
TEST/
CHARGE
POWER
LIGHT
RATIO GN/
MACRO FLASH CONTROLLER
FC-1
MODE
LAMP
AUTO
CHECK
TEST/
CHARGE
POWER
LIGHT
RATIO GN/
MACRO FLASH CONTROLLER
FC-1
MODE
LAMP
AUTO
CHECK
TEST/
CHARGE
POWER
LIGHT
RATIO GN/
MACRO FLASH CONTROLLER
FC-1
MODE
LAMP
AUTO
CHECK
TEST/
CHARGE
POWER
LIGHT
RATIO GN/
30 sec.
10 sec.
Ni-Mh batteries
16

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Olympus FC-1 Macro Flash System bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Olympus FC-1 Macro Flash System in de taal/talen: Engels als bijlage per email.

De handleiding is 4,51 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info