Remedying a paper jam
If too much paper is fed into the cutting unit, a paper jam occurs. Proceed as follows:
- Push the the REV switch.
- The cutting unit runs backwards and pushes the excess paper back.
- Reduce the paper quantity and release switch REV. The cutting unit runs
forward again and the paper still in the cutting unit is shredded.
If the backwards and forwards movement does not remedy the paper jam, pull out the
mains plug and remove the remaining paper manually from the cutting unit.
Notes on care and maintenance
Caution: maintenance work may only be performed when the mains plug is pulled
out.For you to be able to continue using your paper shredder for as long as possible,
clear residual paper from the cutting unit at regular intervals and apply special oil for
paper shreddersto the cutting unit. This special oil is available from specialist dealers.
This will extend the service life of the device.
Motor protection
The motor switches off automatically in the event of overloading. Lamp "Hot" shines.
Pull out the mains plug from the socket and allow the motor to cool down to room tem-
perature. Plug the mains cable back in and then continue operation.
Technical data
Model: PS 406.2C/PS 415.4C
Power supply: 220-240V / 50Hz
Cutting width of the paper slot: 230mm,
size of the cuttings: 2 x 6 mm / 4 x 30 mm
Cutting power: 6 / 15 A4 sheets (80 g/m2)
Security level: 4 / 3
Max. power consumption: 300 W / 350 W
Size (W x H x D): 290 x 240 x 520 mm
Weight: 14 kg
Operating cycle: 10 min
Paper basket: 19 litre
8
