16706
38
Verklein
Vergroot
Pagina terug
1/64
Pagina verder
14
TO RECORD OUTGOING MESSAGE 1
1. Press the key
until the display shows:
TAD SET-UP
2. To confirm the setting, press the key:
The display shows:
ICM ON SPEAKER
3. Press the key
until the display shows:
RECORD OGM1!
4. Press the key:
The display shows:
LIFT HANDSET
5. Lift the handset.
The display shows:
TO RECORD
6. To start recording the message, press the key:
The display shows:
RECORDING 19
You have 20 seconds (counted on the display from 19 to
00) to record your message:
if the message lasts less than 20 seconds, when you
reach the end of the message hang up or press the
key or the key. If you press the key, the fax
machine will not automatically play back the message that
you have recorded.
if the time available runs out, the fax machine emits a
brief beep and automatically plays back the message you
have recorded.
Then hang up.
In both cases, to return the fax machine to the initial stand-
by mode, press the key.
notE
If the volume of the message is too low or too high you can
regulate it, during playback, using the
key. The display shows
the volume level set in the top right-hand corner.
TO LISTEN TO OUTGOING MESSAGE 1
1. Press the key
until the display shows:
TAD SET-UP
2. To confirm the setting, press the key:
The display shows:
ICM ON SPEAKER
3. Press the key
until the display shows:
PLAY OGM #1
4. To listen to message 1 recorded previously, press the key:
The display shows:
PLAYING
When it gets to the end of the message, the fax machine
automatically prepares to record a new OUTGOING MES-
SAGE 1. In this case, if you like, you can change or replace
the message recorded previously by repeating the record-
ing procedure.
5. To return the fax machine to the initial stand-by mode, press
the key:
TO RECORD OUTGOING MESSAGE 2
Record outgoing message 2 as you recorded outgoing message 1,
modifying the step 3 as follows:
Press the
key until the display shows:
RECORD OGM #2
notE
Bear in mind however that you only have 10 seconds.
TO LISTEN TO OUTGOING MESSAGE 2
Play back outgoing message 2 as you played back OUTGOING
MESSAGE 1 modifying the step 3 as follows:
Press the
key until the display shows:
PLAY OGM #2
TO RECORD THE TRANSFER MESSAGE
Record the transfer message as you recorded outgoing messages 1
and 2 modifying the step 3 as follows:
Press the
key until the display shows:
REC.FORW.ANNOUNC
38

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Olivetti LAB_S120 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Olivetti LAB_S120 in de taal/talen: Engels als bijlage per email.

De handleiding is 3,63 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Olivetti LAB_S120

Olivetti LAB_S120 Gebruiksaanwijzing - Nederlands - 64 pagina's

Olivetti LAB_S120 Gebruiksaanwijzing - Deutsch - 64 pagina's

Olivetti LAB_S120 Gebruiksaanwijzing - Français - 64 pagina's

Olivetti LAB_S120 Gebruiksaanwijzing - Italiano - 64 pagina's

Olivetti LAB_S120 Gebruiksaanwijzing - Português - 64 pagina's

Olivetti LAB_S120 Gebruiksaanwijzing - Espanõl - 64 pagina's

Olivetti LAB_S120 Gebruiksaanwijzing - Dansk - 64 pagina's

Olivetti LAB_S120 Gebruiksaanwijzing - Svenska - 64 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info