Loading paper > 32
O
UTPUT
BIN
LINKING
When the output bin reaches its full capacity, the tray’s full sensors are activated and an
error message is displayed on the control panel. If the finisher or stacker is installed, you
can select output bin linking to have the remaining pages sent to an open bin. This option
is turned on by default. You can set this option at the control panel.
M
ANUAL
FEED
The MPF (tray 5) can be used for manual feed. You must change the settings to Manual
Feed on your printer properties. Tray 5 MPF normally operates in multi-purpose mode,
where multiple sheets can be loaded and printed continuously. When in manual mode, you
are prompted to press the start key for each sheet to be printed.
M
EDIA
CHECK
When Media check is enabled (default), the printer first checks the default input source to
see if it has media loaded that matches both the driver requested media type and paper
size. If the default input tray does not contain the requested media, the printer searches
the other input trays to find one that has media matching the requirements. If none is
found, the printer stops and asks you to load the requested media in the default input tray.
You can acknowledge this by pressing On-line whether the correct media is in place or not.
Or you can put the correct media in a tray and then use the control panel to set the media
type for that tray. If it is Tray MPF or the size is not auto detectable, you can also set the
paper size. Otherwise, the printer can auto detect the paper size.
When media check is disabled, the default paper tray will be used to print the document.
The size or type of media in the tray is not a factor in paper tray selection.
The most convenient way to enable this feature is by using your Printer Properties. You may
also enable it at the control panel or use the EWS.
J
OB
OFFSET
The Stacker Main and Standard Top Bin can place sheets in alternate positions to separate
one print job from another. This is called Job Offsetting. When selected, the output position
changes after the final sheet of a print job is printed. Select Job Offset through your printer
properties or enable it at the control panel or use the EWS.
D
RIVER
SETTINGS
When you create groups of settings in your printer properties, you can save those settings
under a name defined by you. You can then use the same settings under the defined name
for other print jobs and save time and effort.
Detailed instructions on how to set these options are contained in the Reference Guide.
