554345
53
Verklein
Vergroot
Pagina terug
1/60
Pagina verder
53
VT 4.0 OPERATING MANUAL
© 2002 Design, 2011 Doc. No. 12-5213-r02 (9/6/11)
TRANSMITTER BATTERY REMOVAL
Locate the Battery Cover on the end of the housing:
Apply a coin to the recessed slot of the Cover and turn it counter clockwise out of the housing (Fig. 141).
Remove the Battery and discard it according to local regulations governing disposal of Lithium batteries.
TRANSMITTER BATTERY INSTALLATION
Lightly lubricate the new Battery Cover O-ring with silicone grease and install it onto the Battery Cover. DO NOT roll the
O-ring over the Threads, instead stretch it slightly to work it down over the slotted end of the Cover into the groove at the base
of the threads (Fig. 142).
The O-ring must be a genuine Oceanic part that can be purchased from an Authorized Oceanic Dealer.
Use of any other O-ring will void the warranty.
• Place a new 3 volt CR2 Lithium Battery (Duracell model DL-CR2 or equivalent) positive (+) side down into the Battery
compartment with the negative end facing up/out (Fig. 143).
• Ensure that the Battery is properly oriented and the Cover O-ring is evenly seated around the Cover.
• Carefully place the Cover (with Spring) into the housing and turn clockwise slowly by hand to ensure proper threading.
• Apply a coin and tighten until secure. The outer surface of the Battery Cover should be flush with the outer surface of the
housing (Fig. 144).
INSTALLING A TRANSMITTER ON A REGULATOR
• Remove the existing pressure gauge and high pressure hose, or the high pressure port plug from the port marked HP using
the proper size hex key.
• Lightly lubricate the o-ring and threads of the Transmitter fitting with a halocarbon based lubricant such as Christo-Lube
MCG111.
• Thread the Transmitter clockwise by hand into the regulator's HP port (Fig. 145) and tighten until secure with an appropriate
sized open end wrench.
• Attach the regulator First Stage to a full scuba tank and pressurize by slowly opening the tank valve, listening for any
indication of air leaking around the fitting.
• If air leakage is present, DO NOT use, take the complete regulator assembly to an Authorized Oceanic Dealer for inspection
and service.
TRANSMITTER COMPATIBILITY WITH NITROX
When packaged and shipped from the factory, Oceanic Transmitters are rated for use with compressed Air and/or nitrogen-
oxygen (Nitrox) breathing gas mixtures containing up to 99% O2 by volume and with 100% O2.
Fig. 143 - ORIENTATION
Battery
(+) ( - )
Fig. 141 - COVER
REMOVAL
Fig. 142 - INSTALLING
COVER O-RING
Fig. 144 - TRANSMITTER
COVER INSTALLED
Fig. 145 - TRANSMITTER ON
FIRST STAGE
53

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Oceanic VT 4.0 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Oceanic VT 4.0 in de taal/talen: Engels als bijlage per email.

De handleiding is 13,14 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Oceanic VT 4.0

Oceanic VT 4.0 Snelstart handleiding - Deutsch - 2 pagina's

Oceanic VT 4.0 Gebruiksaanwijzing - Deutsch - 60 pagina's

Oceanic VT 4.0 Snelstart handleiding - English - 2 pagina's

Oceanic VT 4.0 Gebruiksaanwijzing - Français - 2 pagina's

Oceanic VT 4.0 Gebruiksaanwijzing - Français - 60 pagina's

Oceanic VT 4.0 Snelstart handleiding - Italiano - 2 pagina's

Oceanic VT 4.0 Gebruiksaanwijzing - Italiano - 60 pagina's

Oceanic VT 4.0 Snelstart handleiding - Espanõl - 2 pagina's

Oceanic VT 4.0 Gebruiksaanwijzing - Espanõl - 60 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info