Handleiding Numark DM1125 (pagina 11 van 16) (Engels)

23488

Verklein

Vergroot

Pagina terug

1/16

Pagina verder

DM1125

DIGITAL SAMPLER SECTION

The Sampler uses dynamic RAM with a 12-bit

microprocessor controller. The same digital signal

processing components used in professional audio

equipment deliver high-quality samples.

25. The Mode Knob switches from effect to effect.

Modes are:

• Loop sets the unit to play back a sample and automatically

repeat when it gets to the end of the sample.

• Single sets the unit to play back a sample once.

• Write sets the unit to sampler record ready. Depress the

appropriate assign button to select the source you wish to

record. Selecting a bank you wish to record to and hit the

Start/Stop button (#30) to begin recording (it is safer to

actually choose your bank before going to write mode so

that you don't accidentally wipe out an existing sample). The

LED will stay lit while you are in Write mode. After you are

done writing your sample you should select a play mode

(either Single or Loop) and listen to your sample.

TO RECORD A SAMPLE

a - Select the Write mode to go into stand by mode.

b - Select the bank (or multiple banks) into which you want

to record. Any bank can be selected. Each bank contains 6

seconds of recording time. If you want to record a longer

sample select multiple banks (they must be adjoining). To

playback a multi-bank sample you must reselect the same

banks later. Note: To overwrite an existing sample, select

that bank instead of an empty bank. Changing bank

selection at this point in time is possible and will not destroy

any previously recorded samples.

c - Hit the Start-Stop button to begin recording. The red

LED will light.

d- Hit Start-Stop a second time to stop the sampling, or

allow the memory banks to fill up, at which time sampling will

stop automatically. Once your writing is complete, switch to a

playback mode. The sampler is now ready for playback.

27. The Speed Control plays samples faster or slower

resulting in a pitch shift of the sample. In the center position,

the sample is played at recorded speed. Moving the knob to

the left will slow down playback by up to 50%; moving the

knob to the right will speed up the playback by up to 200%.

Positions near the center provide fine changes in playback

speed. Positions further from the center detent provide

more drastic changes in playback speed.

28. Effect Level Mix fader. This precisely sets the

audible level of the sample in the mix.

29. Memory Bank Select Pushbuttons A-D.

Four banks are available for storing samples. To

record a bank go to Write and then hit the bank

button. You can record into any combination of banks

by pressing multiple bank buttons. After sampling,

you can either select the next bank and record it

(remember Write is still on, just select the bank and

hit Start/Stop) or you can manually select a playback

mode.

• You can play any combination of the Memory Banks

from left to right (that is, Memory Bank B will always

play before Memory Bank D - but you can play ABCD;

BC; BD: ACD; only C; only D; etc.).

30. The large Start-Stop button controls sample

recording and sample playback. The small red Effects

Indicator LED glows when the sampler is "on". Here

are the functions:

• Tap the button when in sampler Write mode to

begin sampling (the LED will light). Tapping it again

ends the sample and the LED goes out. (unless the

sampler has run out of memory and shuts off

automatically.

• In single or loop play without Trigger, tap the

button to play the sample and tap it again to stop the

playback. Every time you play the sample, the music

starts from the beginning of the sample.

• In Single or Loop play with Trigger you are

ready to "stab" samples. With the Trigger Out, the

sample plays all the way through before you can play it

again. With it In, you can stab or stutter a sample.

When you shout "Rock it - rock the house!" and

sample it, it can be played back as -

R-R-R-R-R-R-R-Rock --

Rock-Rock-Rock it - Rock it Rock it -

Rock - - Rock it - rock the house!

by simply "drumming" with your fingers.

31. Monitor Pushbutton. To hear the sample or

effect in the headphones, press this button.

Program Mix still works and you will be able to hear

any other input channels with the Cue buttons

activated.

Numark - The Proven Leader in DJ Technology

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

lees eerst de handleiding door;
controleer of uw vraag al eerder door iemand anders is gesteld;
probeer uw vraag zo duidelijk mogelijk te stellen;
heeft u een probleem en al geprobeerd om dit op te lossen, vermeld dit erbij aub;
heeft u een oplossing gekregen van een bezoeker dan horen wij dat graag in dit forum;
wilt u een reactie geven op een vraag of antwoord, gebruik dan niet dit formulier maar klik op de knop 'reageer op deze vraag';
uw vraag wordt direct op de website gezet; vermijd daarom persoonlijke gegevens in te vullen;

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Numark DM1125 Handleiding

Hulp nodig? Stel uw vraag in het forum

Misbruik melden

Product:

Spelregels forum

Abonneren

Ontvang uw handleiding per email

Stel vragen via chat aan uw handleiding

Uw handleiding is per email verstuurd. Controleer uw email

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

U heeft geen emailadres opgegeven

Uw vraag is op deze pagina toegevoegd

Info