709180
9
Verklein
Vergroot
Pagina terug
1/28
Pagina verder
GB
Connecting the SOLAR-HOME-STATION Deleting all the programmed-in hand
AKKU-POWER-SYSTEM
Connecting plan (4) transmitter codes
Important instructions: - Press the “PRG” button on the SOLAR-HOME-
230V power supply for garage door operators with
- When connecting accumulators and charger STATION and keep it pressed for approx. 10
SOLAR-HOME-STATION SHS200
modules, it is important to observe the correct seconds until the LED starts flickering and then
polarity (fire hazard). goes out
Suitable for:
- When using operators with a protective
conductor connection, the SOLAR-HOME- Setting the operator
Novoferm
STATION must be properly earthed. To set the garage door operator, press the
NovoPort, Novomatic 403 / 553 / 553S and
- Follow all the instructions provided in the appropriate button on the hand transmitter. The
Novodoor
SOLAR-HOME-STATION'S Instruction Manual. SOLAR-HOME-STATION switches the 230V power
- Insert the operator's mains plug into the SOLAR- supply on. Program the operator in accordance
Siebau
HOME-STATION'S electric socket (4c). with the Operating and Installation Instructions.
ATS24, TYPE 403, TYPE 553, TYPE 553S,
- Connect the accumulator pack to the “AKKU”
TYPE 611
input of the SOLAR-HOME-STATION (4d). Attention: after 60 seconds the SOLAR-HOME-
- Do not connect the start cable until you have STATION automatically switches off the 230V
and
programmed the operator for operation of the power supply. Throughout programming, you
garage door (see point 5). The “START” output should therefore operate the hand transmitter
tormatic
on the SOLAR-HOME-STATION is connected to every 30 seconds to maintain the 230V power
GTA 601, GTA 602, GTA 611, GTA 612, GTA 701,
the “START“ input on the garage door operator supply until the process has been completed.
GTA 702, GTA 801 and GTA 802
using a two-core lead (4a, 4b and 4d).
- Connect the solar module (optional) to the Do not connect the start cable until all the
Becker / Rollmatic BV
“MODUL” input on the SOLAR-HOME- necessary settings have been made.
BOM 520, BOM 820
STATION.
Operation
If using operators of other makes, the switch-on
Use the hand transmitter to open and close the
behaviour can lead to malfunctions. Putting into service
door.
The SOLAR-HOME-STATION first switches on the
Charger For the remote control use a free channel on the
230V power supply.
Before being used for the first time, the hand transmitter. If no free channel is available,
After 2 ½ seconds, the station sends a start
accumulator pack must be charged. To do this, delete the transmitter that has been tuned into the
impulse to the operator.
connect the accumulator pack to the charger (1a). operator.
The door automatically travels to the end-of-travel
Plug the charger into the electric socket and set
position.
the slide switch to 12V (1b). The accumulator is Tuning the hand transmitter into the
After 60 seconds, the SOLAR-HOME-STATION
fully charged when the green light comes on. SOLAR-HOME-STATION
switches the 230V-power supply off again. The
Max. charging time 24 hours. - Press the PRG button on the SOLAR-HOME-
light on the operator goes out.
After charging, disconnect the charging cable STATION.
again (1c). - The LED on the SOLAR-HOME-STATION
Changing the accumulator:
flashes.
We recommend that you buy an additional
Installing the SOLAR-HOME-STATION and - Press one of the buttons on the hand transmitter
accumulator pack so that while one accumulator
the wall holder for the accumulator pack and keep it pressed.
pack is in operation, the other can be recharging.
Install the SOLAR-HOME-STATION within - As soon as the LED on the SOLAR-HOME-
accessible range of the operator's mains cable (0). STATION flashes rapidly, the hand transmitter
Change the accumulator as explained in 3a, 3b.
To do so, hold the station against the wall and has been tuned in.
Charge the accumulator pack as shown in section
mark the drill holes. Fix in place using suitable
1.
screws and wall plugs (2). Repeat the process for any further hand
Affix the wall holder for the accumulator pack transmitters. Up to 60 codes can be programmed
within accessible range of the SOLAR-HOME- in.
STATION using suitable screws and wall plugs (2).
1
2
4
5
Retain these installation, operating and maintenance instructions for the full duration of the operator’s service life!
9

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Novoferm APS 230 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Novoferm APS 230 in de taal/talen: Nederlands, Duits, Engels, Frans, Spaans als bijlage per email.

De handleiding is 1,57 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Novoferm APS 230

Novoferm APS 230 Aanvulling / aanpassing - Alle talen - 1 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info