7
1 Camera Setup
1.1 Power Supply
The camera uses either 4 AAA-Size batteries (alkaline battery
recommended) or the household AC power current.
Loading the Batteries
1. Loosen the screw on the bottom of the camera by using a screw driver.
See Fig. 3.
2. Open the battery compartment cover . See Fig. 3.
3. Insert 4 AAA-size batteries (follow the plus (+) and minus (-) signs
inside the battery compartment). See Fig. 3.
4. Close the battery compartment cover, and make sure it is locked
securely.
Note 1:
Do not mix old batteries with new ones.
Note 2:
Remove the batteries from the camera if you do not plan to
use it for a prolonged period of time.
5. Slide the POWER switch to the ON position. The LED on the camera
will light up (red light). See Fig. 3.
Note:
When battery power is sufficient, the light is constantly red; when
the battery is low, the LED light will start blinking.
Using AC Power
1. Plug one end of the provided power adapter into a wall outlet and the
other end into the bottom of the camera. See Fig. 4.
2. Slide the ON/OFF switch to the ON position. The LED on the camera
will light up (red light). See Fig. 4.
1.2 Fine Tuning
Place the camera in a convenient location, point the lens towards the
observation area and adjust the angle by rotating the lens head.
See Fig. 5.
Find the best location for the camera before installing the wall bracket.
1.3 Night light
Press the night light button, the night light LEDs will remain ON.
See Fig. 6.
Setup
