Fine tuning
Place the camera in a suitable location and
point the lens (A1) toward the observation area
by rotating the lens body (A3) vertically.
Adjust the focus by turning the lens knob (A2)
until the image is sharp.
Night vision
The camera has six infrared LEDs (A4) that give
you clear images in the dark. To activate the
infrared function, move the switch (A11) to the IR
position.
When using the night vision function, the picture
automatically goes into black and white mode.
The night vision function is disabled when
running on battery power.
Low battery power indicator
The LED indicator for low battery power (A6)
lights up when the batteries need to be replaced.
Power supply
The monitor can run on the power adapter and
the pre-installed LI-ION rechargeable battery.
Charging time is 1 to 4 hours, whether the
monitor is off or on. When the monitor is turned
off and the charging is completed, the indicator
for fully charged battery (B6) lights up. The bat-
tery will work approximately 6 hours with the
monitor flipped down and 2 to 3 hours with the
monitor open.
Using the power adapter
Plug the power adapter labelled OUTPUT: 5V
DC into a wall socket and plug the adapter
plug into the rear of the monitor (B14).
Move the ON/OFF switch (B13) to the ON
position
.
Adjust the volume (B9) to the desired level.
Adjust the brightness (B10) to the desired level.
Channel selection
Only one switch (B11) must be moved to the
ON position.
Select Channel 1 by moving CH SEL 1 to ON
Select Channel 2 by moving CH SEL 2 to ON
Select Channel 3 by moving CH SEL 3 to ON
Select Channel 4 by moving CH SEL 4 to ON
Check that you select the same channel as on
your camera.
