12
INSTALLATION
POWERING OFF THE PROJECTOR
1 Press the “Power/Standby” button to turn off the projector lamp, you will see a
message “Power off the lamp?” on the on-screen display.
2 Press the “Power/Standby” button again to confirm. Otherwise the message will
disappear after 5 seconds.
3 The cooling fans continue to operate for about 60 seconds for cooling cycle and
the “Power/standby” button will turn orange. When the light begins flashing, the
projector has entered standby mode.
If you wish to turn the projector back on, you must wait until the projector has
completed the cooling cycle and has entered standby mode. Once in standby
mode, simply press “Power/ Standby” button to restart the projector.
4 Disconnect the power cord from the electrical outlet and the projector.
5 Do not turn on the projector immediately following a power off procedure.
Warning Indicator
When the “LAMP” indicator lights solid orange for about
2 minutes, the projector will automatically shut itself
down. Please contact your local reseller or service center.
When the “TEMP” indicator lights solid orange, it
indicates the projector has been overheated. You will
see a message “Projector Overheated.” on the on-screen
display. The projector will automatically shut itself
down. Under normal conditions, the projector can be
switched on again after it has cooled down. If the
problem persists, you should contact your local dealer or our service center.
When the “TEMP” indicator flashs orange for about 10
seconds, you will see a message “Fan fail. Lamp will
automatically turn off soon.” on the on-screen display.
Please contact your local dealer or our service center.
