44
reservoir using the assembly tool on
the end of the measuring spoon.
➔ Fill up the reservoir with fresh
water and put it back in the machine.
➔ Hold a container under the steam /
hot water jet (fig. 1/T) and turn the
control knob (fig. 1/Q and 7) to the
right to open. The system will now be
rinsed out.
➔ Wait until no more water comes out
of the jet for a short time and turn
the control knob (fig. 1/Q and 7) back
to the left to close. (Caution: If water
continues to come out of the jet after
a short while, the system is also ready.
If this occurs, turn the control knob
back to the left anyway.)
➔ The system briefly warms up
(“SYSTEM IS HEATING” appears in
the display), and is then operational
again.
➔ Note: The service button (fig. 1/I)
may still flash. Press the button (fig.
1/I) and the system will briefly be
rinsed out through the coffee spout
(fig. 1/J and 5).
Important: If you use a filter for your
machine and have changed the funct -
ion setting to “FILTER YES” the water
hardness and function will no longer
be shown. Internal device automati-
cally sets the water hardness to Level
1. This means you only need to des-
cale your appliance occasionally –
always when indicated by the messa-
ge on the display and at all times
with the filter removed.
The filter loses its efficiency after pro-
cessing about 50 l of water (for chang-
ing filter, see chapter 5.2).
Caution: If the machine is rarely used
and the “CHANGE FILTER” signal does
not appear in the display, the filter
must be re placed anyway after no
longer than two months (see chapter
5.2 “Washing filter manually”).
Operating without a filter:
If you no longer wish to use a filter, the
filter setting must be changed back to
“FILTER NO”. This is important, as
without a filter the machine must be
descaled more often (the machine is
delivered in the default sett ing “FIL-
TER NO”).
➔ Press the program key P to enter
programming mode.
➔ Press the > key until “PROGRAM
FILTER” appears in the display.
➔ Press the ok key.
➔ Press the > key until “FILTER NO”
appears in the display.
➔ Press the ok key to confirm. The
display reads: “PROGRAM FILTER”.
➔ You can now either continue in pro-
gramming mode to change other func-
tion settings or press exit to leave pro-
gramming mode.
Note: Do not forget to set the water
hardness now (see point 4.3).
4.3 Water hardness
Depending on the water hardness in
your region, also if you have inserted
a filter (see chapter 4.2), the machine
needs descaling sooner or later. So
that the system can indicate correctly
when des caling is necessary, you
must enter the correct water hardness
settings before the first use.
Not during filter use – during ‘opera-
tion with filter’ with the corresponding
programming, the water hardness is
automatically set to Level 1.
The default setting is level 3.
... 4. Programming functions
