14 © 2015 UTC Fire & Security Americas Corporation, Inc. All rights reserved.
Enrolling, Defaulting and Retrieving the IP
Address for the NX-595E
The NX-595E is automatically set to device address 191 and programming is
carried out like all other NetworX modules.
Default the NX-595E following these instructions depending on the type of keypad
you are using. When you exit program mode, the NX-595E will be automatically
enrolled.
Using a NX-181xx Voice keypad
Selects main menu - Option 0, Advanced system
configuration
Enter your code, touch menu to exit.
Enter your 4 or 6 digit Programming code
Touch 1 for keypad configuration
Touch 2 for panel and device configuration
Touch 3 to configure service provider phone
number
Touch menu to exit.
Selects Panel and Device configuration
Select a device number followed by enter
Touch menu to go back.
Connects to device 191 (NX-595E)
Selected device 191 is connected.
Select a Location number followed by enter
Touch menu to go back.
Defaults the device, Note: only required once
This keypad will announce the first number of the IP
address
This keypad will announce the second number of the
IP address
This keypad will announce the third number of the IP
address
This keypad will announce the fourth number of the IP
address
Moves back to step 4, select a device number
Moves back to step 3, Advanced system configuration
selection.
Exits from Advanced system configuration. (exiting
program mode automatically enrolls the NX-595E)
