16
Filters and maintenance
Installation:
Attention: The halogen bulbs must be
switched off and must have cooled down.
1. Remove the metal filters (see "Removing
and inserting the metal grease filters").
2. Insert the activated-carbon filters. To do
this, connect the filters to the pins on the
sides of the fan.
Removing the filter:
Attention: The halogen bulbs must be
switched off and must have cooled down.
1. Remove the metal filters.
2. Rotate the filters against the direction of
the arrow and pull them out.
3. Insert the metal grease filters.
Replacing the activated carbon filter:
❑ During normal operation (1 to 2 hours
per day) the activated carbon filters
should be replaced approximately 1 x
year.
❑ A replacement filter can be obtained
from any authorized dealer.
❑ Use original filters only.
By doing so you will obtain maximum
performance from your extractor hood.
Disposing of the old activated carbon
filter:
❑ There are no pollutants in the activated
carbon filters. They can therefore be
disposed of as part of your normal
domestic refuse.
3. Rotate the filters in the direction of the
arrow until they engage. If the filters have
been installed correctly, they can no
longer be removed.
4. Insert the metal grease filters (see
"Removing and inserting the metal
grease filters").
5. Clearing the
ã display.
❑ Press the 0 button 2 x in
succession. A signal sounds and the
C display goes out.
