en Operating the appliance
30
Zeolith drying ¼
Zeolith drying
:Warning
Risk of burns from touching the blow
opening 1R!
Never touch the blow opening. The blow
opening becomes hot and, furthermore,
any damage will result in a chargeable
callout by customer service.
Caution!
Please ensure that the intake opening
1J is not obstructed and do not place
any temperature-sensitive utensils in the
lower basket at the rear right side above
the blow opening 1R.
The appliance features a Zeolith
container. Zeolith is a mineral which can
store moisture and heat energy
and release them again.
During the washing step this heat
energy is used to dry the mineral
and heat up the rinsing water.
During the drying phase moisture from
the rinsing compartment is stored in
the mineral and heat energy
is released. This released heat energy is
blown into the rinsing compartment with
dry air. This accelerates and improves
drying.
These processes therefore save a great
deal of energy.
Time display
The running time is determined during
the programme by the water
temperature, the number of utensils as
well as the degree of soiling and may
vary (depending on the selected
programme). You can change the time
display in time or hours/minutes so that
the remaining running time of the rinsing
progamme appears in the display
window “Ready at” (for example 15:20
hours) or “Ready in” (for example 3:25).
Sensor setting
The programme sequence is optmised
in Auto programmes with the aid of
sensors. The sensors adjust the
programme strength of Auto
programmes depending on the amount
and type of soiling. You can adjust the
sensitivity of the sensors in 3 stages.
Standard: This setting is ideal for a
mixed load and heavily soiled utensils,
but also saves energy and water.
Sensitive: This setting adjusts the
programme strength for the effective
removal of food remnants, even if the
amount of soiling is low. The energy and
water consumption is adjusted
accordingly.
Very sensitive: This setting adjusts the
programme strength for difficult
conditions of use, for example firmly
dried on food remnants. This setting is
recommended if using biological or eco
detergents which contain lower
amounts of active agents. The energy
and water consumption is adjusted
accordingly.
extraDry
The final rinse uses a higher
temperature which improves the drying
result. The running time may increase
slightly. (Caution if utensils are delicate!)
You can switch the extraDry function on
or off.
Eco forecast
When Eco forecast is activated, the
average water and energy consumption
of the selected programme is briefly
displayed on the display window at the
top @.
