12
iCN 600 series | User Manual
Getting started
Adhesive Tape and Screw-Mount*
You can use the baseplate, adhesive tape and screws supplied to permanently mount the iCN
directly into the vehicle dashboard.
Note: This is a permanent solution. Once fixed, the adhesive tape cannot be removed.
*iCN 630, 635, 650 only
Assembling the iCN Screw-Mount
1. Choose a position on the dashboard where the iCN will be clearly visible to the driver,
and ensure that the mounting surface is clean and dry.
2. Remove the protective layer from the tape and press down firmly for 30 seconds.
3. Press the suction-cup firmly against the surface and press the lever down.
4. Use the baseplate and screws supplied to fix the iCN base into the dashboard.
5. Slip the locking-nut over the ballfoot, with the flat side facing upwards.
6. Snap the socket-clip onto the ballfoot.
7. Screw the locking-nut onto the thread of the socket-clip until firm.
Inserting the iCN into the Screw-Mount
1. Snap the iCN onto the socket-clip. Position the two locating-tabs on the underside of the
iCN into the corresponding slots on the socket-clip. Then push the iCN into the clip.
2. Open the GPS antenna outwards, so it has a clear view of the sky.
3. Plug the power-cable into the socket on the left side of the iCN and the other end into
the 12 V vehicle power-socket.
