470008
26
Verklein
Vergroot
Pagina terug
1/30
Pagina verder
FISH 4350 / 4380 Installation and Operation Manual26
NAVMAN
switching off other instruments, accessories
(e.g. bilge pump) and the motor until the
offending device is located. To stop
problems from electrical noise, try:
- re-routing the power and transducer
cable(s) away from the boat’s other
electrical wiring.
- routing the display unit’s power cable
directly to the battery with an in-line fuse.
4. Bottom is not displayed:
a) The Þ shÞ nder may have Manual Range
selected and the depth may be outside the
range value selected. Either change the
Þ shÞ nder to Auto Range or select another
depth range (see section 4-4 Range).
b) The depth may be outside the Þ shÞ nder’s
range. While in Auto Range, the display
unit will display “--.-” to indicate that there is
no bottom detected. A display of the bottom
should reappear when in shallower water.
5. The bottom is displayed too far up
the screen:
The Þ shÞ nder may have Manual Range
selected and the selected Range value is
too high for the depth. Either change the
Þ shÞ nder to Auto Range or select another
depth range (see section 4-4 Range).
6. Bottom echo disappears or erratic
digital reading while the boat is moving:
a) Ensure the back of the bottom surface
of the transducer is slightly lower than
the front and the front is as deep in the
water as possible in order to minimise the
generation of bubbles through cavitation.
(See the Transom Transducers Installation
Guide, for more information.)
b) The transducer may be in turbulent water.
Air bubbles in the water disrupt the echoes
returned, interfering with the Þ shÞ nder’s
ability to Þ nd the bottom or other targets.
This often happens when the boat is
reversed. The transducer must be mounted
in a smooth ß ow of water in order for the
Þ shÞ nder to work at all boat speeds.
c) Electrical noise from the boat’s motor
can interfere with the Þ shÞ nder. Try some
suppression spark plugs.
7. If the Þ shÞ nder beeps when turned on
but nothing is displayed:
The Þ shÞ nder may be operating, but the
backlight settings may have been set too
low. See section 2 Basic Operation, to adjust
the Þ shÞ nder backlight. (Press
twice)
8. The wrong language is displayed:
See section 3-1 Setup > System.
9. Fuel used or remaining seem inaccurate:
a) If the engine is run while the Þ shÞ nder is
powered off, the Þ shÞ nder does not record
the amount of fuel used during that engine
run. Consequently, the Fuel remaining
value will be higher than the actual amount
of fuel remaining in the tank.
To avoid this problem, use the Auto Power
Wiring option described in section 6-4 Wiring
options. This ensures that the fishfinder
powers on automatically whenever the
boat’s ignition is switched on.
b) In rough seas, fuel may surge back and
forth through the fuel transducer, resulting in
incorrect readings. Try installing a one-way
valve between the fuel transducer and the
fuel tank.
c) The Set remaining fuel value must be
reset after every refuelling (see section 3-3
Setup > Fuel).
d) The fuel tank may not reÞ ll to the same
capacity each time due to air pockets. This is
particularly noticable with underß oor tanks.
e) Fuel transducers wear out over time and
should be replaced after every 5000 litres
of fuel.
10. Flow indicates no fuel or low fuel:
a) Check that the number of engines is set
to 1. See section 3-3 Setup > Fuel.
b) Check that the fuel cable connectors are
securely plugged in and the collar is locked
in place. The collar must be locked in place
to give a watertight connection.
c) A fuel transducer may be clogged. If so,
remove the transducer from the fuel line
and gently blow through it in the opposite
direction to the fuel ß ow.
A fuel Þ lter between the fuel transducer
and the fuel tank must be installed as per
the fuel installation guide. Failure to do so
will void the warranty.
d) Inspect the fuel cable from end to end for
damage such as cuts, breaks, trapped or
squashed sections.
e) Check that the fuel Þ lter is clean.
11. A twin engine installation shows only
one ß ow rate:
a) Check that the number of engines is set
to 2. See section 3-3 Setup > Fuel.
26

Hulp nodig? Stel uw vraag in het forum

Spelregels

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Navman FISH 4350 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Navman FISH 4350 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,62 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Andere handleiding(en) van Navman FISH 4350

Navman FISH 4350 Gebruiksaanwijzing - Nederlands - 31 pagina's

Navman FISH 4350 Gebruiksaanwijzing - Deutsch - 31 pagina's

Navman FISH 4350 Gebruiksaanwijzing - Français - 34 pagina's

Navman FISH 4350 Gebruiksaanwijzing - Italiano - 32 pagina's

Navman FISH 4350 Gebruiksaanwijzing - Português - 35 pagina's

Navman FISH 4350 Gebruiksaanwijzing - Espanôl - 35 pagina's

Navman FISH 4350 Gebruiksaanwijzing - Svenska - 29 pagina's


Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info