470014
21
Verklein
Vergroot
Pagina terug
1/32
Pagina verder
21FISH 4200 Installation and Operation Manual
NAVMAN
Calibrating the Temperature
The factory settings should be sufficiently accurate
for normal usage. However, to calibrate the
temperature readout, first measure the water
temperature.
Then, to calibrate the setting, select TEMPERATURE
then press
to display the temperature readout box.
Press
or
to increase or decrease the value to
match the measured temperature.
(To change the temperature units between °F
(Fahrenheit) or °C (Celsius), use the SETUP - UNITS
menu (see section 4-2).
Calibrating the Speed
Use this to calibrate the boat's speed and log.
Calibration may be required because different hull
shapes have different flow characteristics.
Obtain an accurate measurement of the boat's speed
from a GPS receiver; by following another boat
traveling at a known speed; or by making a timed
run over a known distance.
Note that for accurate calibration:
· the speed from a GPS receiver should be
greater than 5 knots.
· the speed from another paddlewheel transducer
should be between 5 and 20 knots.
· best results are achieved in calm conditions
where there is minimal current (best at high or
low tide).
Use
or
to highlight the SPEED option, then press
to display the speed readout box. Press
or
to
increase or decrease the readout to match the
independent speed value.
4-9 CALIBRATION menu
Use this menu to
calibrate water
temperature boat
speed, fuel
readings and the
fuel flow filter.
Select MAIN MENU
- SETUP - INSTALL
- CALIBRATION to
display the
calibration menu.
Calibrating the Fuel
Use this to calibrate the fuel usage. Calibrating the
fuel usage can improve the accuracy of fuel
measurements.
Twin engine installations require each fuel transducer
to be calibrated. This can be done at the same time
with two portable tanks, or at different times using
one portable tank.
Calibrating the fuel transducer requires accurate
measurement of the fuel consumption. This is best
done using a small portable tank. At least 4 gallons
(15 litres) of fuel should be used to ensure an
accurate calibration.
It is often very difficult to fill underfloor tanks to the
same level twice due to air pockets, so the more fuel
used, the more accurate the calibration.
To calibrate a fuel transducer, perform the following
steps:
1 Select MAIN MENU - SETUP - FUEL and then
select the CLEAR USED option. Press
to select
YES.
2 Note the level of the fuel in the tank.
3 Connect the portable tank to the engine through
the fuel transducer.
4 Run the engine at normal cruising speed until at
least 4 gallons (15 litres) of fuel has been used per
engine.
5 Check the actual amount of fuel used per engine
by refilling the portable tanks to the original level and
noting the reading from the fuel dispensers gauge.
6 Select MAIN MENU - SETUP - INSTALL -
CALIBRATION - FUEL, then press
or
to change
the reading to match that on the fuel dispensers
gauge.
7 Press
when the reading is correct.
(Repeat the procedure for the other engine in a twin
engine installation).
Note: If the fuel calibration options appear to give
erroneous readings after being used for a while, first
check that the fuel sensor has been installed correctly
according to the Installation Instructions supplied with
it, and then refer to the trouble-shooting section in
Appendix B of this manual.
21

Hulp nodig? Stel uw vraag in het forum

Spelregels
1

Forum

Navman-FISH-4200

Zoeken resetten

  • Hallo ik zoek een adres om onderdelen voor de navman fishfinder 4200 te bestellen, het gaat om het wieltje buiten de boot tbv de snelheid
    Wie kan mij helpen?
    Jandekreyjdk@gmail.com Gesteld op 8-2-2015 om 16:01

    Reageer op deze vraag Misbruik melden
    • Hallo Jan heb jij al een adres gevonden? ik ben ook op zoek ik moet een verleng kabel hebben voor mijn transducer.

      marceldapp@hotmail.com

      Alvast bedankt.
      Marcel Geantwoord op 15-6-2015 om 18:29

      Waardeer dit antwoord Misbruik melden

Misbruik melden

Gebruikershandleiding.com neemt misbruik van zijn services uitermate serieus. U kunt hieronder aangeven waarom deze vraag ongepast is. Wij controleren de vraag en zonodig wordt deze verwijderd.

Product:

Bijvoorbeeld antisemitische inhoud, racistische inhoud, of materiaal dat gewelddadige fysieke handelingen tot gevolg kan hebben.

Bijvoorbeeld een creditcardnummer, een persoonlijk identificatienummer, of een geheim adres. E-mailadressen en volledige namen worden niet als privégegevens beschouwd.

Spelregels forum

Om tot zinvolle vragen te komen hanteren wij de volgende spelregels:

Belangrijk! Als er een antwoord wordt gegeven op uw vraag, dan is het voor de gever van het antwoord nuttig om te weten als u er wel (of niet) mee geholpen bent! Wij vragen u dus ook te reageren op een antwoord.

Belangrijk! Antwoorden worden ook per e-mail naar abonnees gestuurd. Laat uw emailadres achter op deze site, zodat u op de hoogte blijft. U krijgt dan ook andere vragen en antwoorden te zien.

Abonneren

Abonneer u voor het ontvangen van emails voor uw Navman FISH 4200 bij:


U ontvangt een email met instructies om u voor één of beide opties in te schrijven.


Ontvang uw handleiding per email

Vul uw emailadres in en ontvang de handleiding van Navman FISH 4200 in de taal/talen: Engels als bijlage per email.

De handleiding is 0,22 mb groot.

 

U ontvangt de handleiding per email binnen enkele minuten. Als u geen email heeft ontvangen, dan heeft u waarschijnlijk een verkeerd emailadres ingevuld of is uw mailbox te vol. Daarnaast kan het zijn dat uw internetprovider een maximum heeft aan de grootte per email. Omdat hier een handleiding wordt meegestuurd, kan het voorkomen dat de email groter is dan toegestaan bij uw provider.

Stel vragen via chat aan uw handleiding

Stel uw vraag over deze PDF

loading

Uw handleiding is per email verstuurd. Controleer uw email

Als u niet binnen een kwartier uw email met handleiding ontvangen heeft, kan het zijn dat u een verkeerd emailadres heeft ingevuld of dat uw emailprovider een maximum grootte per email heeft ingesteld die kleiner is dan de grootte van de handleiding.

Er is een email naar u verstuurd om uw inschrijving definitief te maken.

Controleer uw email en volg de aanwijzingen op om uw inschrijving definitief te maken

U heeft geen emailadres opgegeven

Als u de handleiding per email wilt ontvangen, vul dan een geldig emailadres in.

Uw vraag is op deze pagina toegevoegd

Wilt u een email ontvangen bij een antwoord en/of nieuwe vragen? Vul dan hier uw emailadres in.



Info