LEARNING CODES FROM OTHER REMOTES
Begin by positioning the HTR L76 “nose-to-nose” with the source remote so the two devices’ infrared
windows are about 2 inches apart.
• Enter Learning Mode: On the HTR L76, simultaneously press-and-hold for 3 seconds both a Device
Selector key and the “OPEN/CLOSE” key (just below the “DISP” key), until the Learn LED at
the centre of the HTR L76 turns steady green.
•Press the HTR L76’s function key you wish to teach a command; the Learn LED will turn amber.
•Press-and-hold the function key on the source remote: The HTR L76’s Learn LED will flicker amber
for a second or two, then turn solid green. The command is learned.
•Press the HTR L76’s Device Selector key again to exit the learning mode.
If the Learn LED does not flicker amber you may need to vary the distance between the remotes. If the
Learn LED turns red rather than green, that particular command of that source remote command could
not be learned.
CANCEL OPERATION
You can cancel configuring a key, by pressing the active Device Selector key before the learn process is
complete; the Learn LED will turn red.
Example: Learning “VCR Pause”:
Position the HTR L76 and your VCR player’s remote as described above.
• On the HTR L76, simultaneously press-and-hold “VCR” and ; the Learn LED turns steady
green.
•Press the HTR L76’s (pause) key; the Learn LED turns amber.
•Press-and-hold the VCR player’s remote’s pause key; the HTR L76’s Learn LED flickers amber and
then turns solid green. The command is learned.
•Press “VCR” again to exit the learning mode.
PUNCH-THROUGH
The HTR L76’s “punch-through” function allows you to retain a function key from one Device Select
“page” on another, so that, for example, the AMP “SURR MODE” function might still control the L76
when the DVD Device Selector page is active
NOTE
The HTR L76’s “VOL” and “MUTE” keys are pre-programmed as “punched-through” for all Device
Select pages: “VOL” will operate the L76’s master-volume regardless of the currently selected device.
The “SURR.” “CENTER,” and “SUB” Channel Volume controls similarly are pre-programmed as
punched-through.
To set a punch through, after entering the Learning Mode, and pressing the desired key to be punched-
through, simply press the device key twice of the device to punch through to. The status LED will turn
green; press the Device Selector key again to exit Learning Mode.
Example: Punch-through the from the DVD “page” to the AMP “SURR MODE” key:
• On the HTR L76, simultaneously press-and-hold “DVD” and (OPEN/CLOSE); the Learn LED
turns steady green.
•Press “SURR MODE”; the Learn LED turns amber.
•Press “AMP” twice; the Learn LED turns green.
•Press “DVD” again to exit the learning mode.
IDENTIFICATION OF CONTROLS
