1110
running.
• Do not press too hard on the
pusher (A). Do not use any other
utensil.
NEVER push food with your
fingers.
• When you have finished, stop the
appliance by turning the control
button (J) to 0 and wait until the
sieve (D) stops completely.
• When the pulp collector (H) is full,
or the juice flow slows down,
empty the pulp collector (H) and
clean the sieve (D) and the cover
(C).
• After making your juice, turn the
non-drip spout (G) by 180° before
removing the glass to stop the
juice flow (see Fig. 6).
Ingredients Approximate weight (kg)
Quantity of juice
obtained in ml (*)
– 1 glass = 200 ml
(approximately)
Apples 1 650
Pears 1 600
Carrots 1 600
Cucumbers 1 (about 2 cucumbers) 600
Pineapple 1 300
Grapes 1 450
Tomatoes 1 600
Celery 1 600
(*) The quality and quantity of juice varies widely depending on the
freshness of the fruit or vegetables and variety of each vegetable or
fruit.
The quantities of juice indicated above are therefore approximate.
SAFETY SYSTEM
To start the juicer, the cover (C)
must be fitted correctly (Fig. 2).
At the end of a cycle, turn the
control button to "0" and wait until
the sieve (D) stops completely
before removing the cover (C).
BEFORE FIRST USE
We recommend that you wash the
removable parts (A, B, C, D, E, F, G,
H) before the first use (see section
"Cleaning and care").
• Unpack the appliance and then
place it on a solid, stable worktop,
remove the cover (C) and take
out the protective card on the
sieve (D).
USING THE APPLIANCE
• Place the juice collector (E) on
the body of the appliance
(see Fig. 1).
• Place the sieve (D) in the juice
collector (E). Ensure that the sieve
is properly clipped onto the drive
shaft (K) (see Fig. 1).
• Fit the cover (C) on the
appliance in order to have the
pulp evacuation exit to the rear
(see fig.2).
• Fit the pulp collector (H) on the
rear of the appliance
(see Fig. 3).
• Lock the two clamps (I) on the
cover (C). You will hear an
audible “click” (see Fig. 4).
• Slide the pusher (A) into the feed
tube (B) aligning the groove on
the pusher with the small ridge in
the feed tube.
• Your appliance is equipped with
a non-drip spout (G). Fit it (spout
downwards) on the pouring
spout (Fig. 5).
• Place a glass under the non-drip
spout in front of the appliance
(see Fig. 5).
• Plug in the appliance.
• To start the appliance, use the
control button (J).
• Cut the fruits or vegetables into
pieces if necessary after removing
the stones.
• Insert the fruits or vegetables
through the feed tube (B).
• The fruits and vegetables must be
inserted only while the motor is
Do not use the appliance for more than 1 minute continuously.
